AC and DC Dynamo, galvanometers, etc...
ewan ko
Faraday says you will induce a current in the wire.
because when we inoculate the culture with wire loop,some organism may be sticked to it which may be harmful or can cause trouble.so to destroy the remaining organisms wire loop is flamed again.
in the same direction as the field
In a very simple, laboratory-type, a.c. generator -yes. In practical generators, the output (armature) windings are part of the stator, so do not rotate and, so, don't require slip rings.
The shape of the loop of wire is two concentric semicircles.
The torque acting on the loop in this scenario is the rotational force that causes the loop to rotate around its axis.
When no net force acts on a loop of wire in a magnetic field, the loop will not experience any acceleration or movement.
ewan ko
why, if the same current flows in a wire coil and a single loop, the magnetic field inside the coil stronger than the field inside the loop
Yes, it is possible to orient a current loop so that it does not tend to rotate in a uniform magnetic field. This can be achieved by aligning the plane of the current loop perpendicular to the direction of the magnetic field. In this configuration, there will be no net torque acting on the loop, thus preventing it from rotating.
No it will not. In order to get electrical activity you need motion. Either the magnet or the wire must move.
Increasing the strength of the magnetic field passing through the loop, increasing the number of turns in the wire loop, or increasing the speed at which the magnetic field changes can all increase the current in a stationary wire loop through Faraday's law of electromagnetic induction.
When an electric current runs through a loop of wire, it generates a magnetic field around the wire. This phenomenon is known as electromagnetism.
The magnitude of induced current in a wire loop when exposed to a changing magnetic field is determined by factors such as the strength of the magnetic field, the rate of change of the magnetic field, the number of turns in the wire loop, and the resistance of the wire.
because when we inoculate the culture with wire loop,some organism may be sticked to it which may be harmful or can cause trouble.so to destroy the remaining organisms wire loop is flamed again.
you should drawn the loop slowly from the cooler to the hotter part of flame.Heat from the base of the wire first and slowly move towards the loop's tip. Heat the wire until it is red-hot.