A pull-up resistor common 4K7 is normally used on ICs where a pin is floating to pull the pin to 5 volt or logic 1 it can be pulled to logic 0 internally by the IC it is normally used with MCUs (micro processors)
resister is nothing but a 'clay' which will reduce the flow of current. There by limiting the volt.
A: That refers to a resistor pull up that is not sufficient to do the job that is to pull up. It also means is greater in value that it should be
To impede the flow of current
Using Ohms Law, the answer is 120/0.5 = 240 Ohms.
series network consists of components i.e resisters connected end to end. since their is only one path for the flow of current. but potential drop across each resister is different. so thats the reason that series network has maximum resistence then the highest resister in combination. the same amount of current passes through each resister.
pull up resistor is a one of the dubakur resister
Only port 0 needs pull-up resistors to be connected externally if you want to use it as out put port, because it has no in built pull up circuit so it can't give +5v as out put. refer micro controller and applications book by mahmed ali mazidi.
Group of resister is called as gang resister
A resister is a person who resists or opposes something.
right beside the blower there is a plug ..unplug it and remove the two screws ...pull out your resister
right beside the blower there is a plug ..unplug it and remove the two screws ...pull out your resister
shaking the blower resister
Where is heater resister on 02 buick century
An engineer who knows the secret color code can glance at the resister and instantly know the resistence of the resister in ohms.
resister is nothing but a 'clay' which will reduce the flow of current. There by limiting the volt.
in embedded system resister means, memory to store the data.
Take out the glove box there you will see the heater motor the back of that is the resister you will need to get on yyour back to reach up to it.it should slide out