The BC557 is a PNP bipolar junction transistor (BJT) commonly used for switching and amplification applications. It has a maximum collector current of 100 mA and a maximum collector-emitter voltage of 45 V. The transistor features a low noise figure and is suitable for low-power applications, making it a popular choice in consumer electronics. Its pin configuration typically includes the emitter, base, and collector in a TO-92 package.
A silicon transistor is a transistor made of silicon.
Similar to a 2N3906 PNP transistor
I believe that is resistor transistor technology TTL transistor transistor logic
It depends on the transistor, you just have to look at the data sheet for the transistor.
The BJT is the bipolar junction transistor, the PCT is the point contact transistor, the UJT is the uni-junction transistor, the SBT is the surface barrier transistor, the FET is the field effect transistor, the GJT is the grown-junction transistor, the AJT is the alloy-junction transistor, and the DFT is the drift field-junction transistor.
it is a transistor used in IR TOGGLE SWITCH. :-)
The BC548 and BC557 are different types of transistors; the BC548 is an NPN transistor, while the BC557 is a PNP transistor. Because of this fundamental difference, they cannot be used interchangeably in circuits that require specific transistor types for operation. If your application requires a PNP transistor, you cannot substitute a BC548 for a BC557 without altering the circuit's design. Always ensure the transistor's characteristics match the requirements of your application.
No, it's a PNP general purpose transistor.
Transistors have many characteristics and they most certainly require voltages to be a certain polarity if they are to work properly. There are two main types of transistor: PNP and NPN. They are identical except that all polarities are reversed on one compared to the other. There are many books and online resources that describe transistors but here is a very brief note about transistor operation. Each transistor has a base, a collector and an emitter. When a small current is passed from the base to the emitter, a larger current will pass from the collector the the emitter. With an NPN transistor, the base needs to be positive with respect to the emitter and the collector also has to be positive with respect to the emitter for the transistor to work. A PNP transistor is reversed, where both the base and the collector need to be negative with respect to the emitter to operate. Therefore, transistors do indeed have a polarity, even if it is more complex that some other devices. Disclaimer: The above description of transistor operation is greatly simplified and there are operational modes that are outside the conditions described. Please don't use the above description as a definitive guide to transistor behaviour.
A silicon transistor is a transistor made of silicon.
The active region of a transistor is when the transistor has sufficient base current to turn the transistor on and for a larger current to flow from emitter to collector. This is the region where the transistor is on and fully operating.
A Unijunction Transistor is a transistor that acts solely as a switch.
Similar to a 2N3906 PNP transistor
how does a transistor behaviour
Power transistor can conduct large amount of currents through it, more than small signal transistor. power transistor has a vertical structure and small signal transistor has horizontal structure.In power transistor quasi saturation region is present which is absent in the small signal transistor. In power transistor there is a inculsion of drift layer which is not there in the small signal transistor. Power dissipation is less in power transistor and it is more in small signal transistor. b.v.polytechnic,vasai pushkar vaity.
I believe that is resistor transistor technology TTL transistor transistor logic
I can give you several sentences.I bought a transistor radio.The transistor amplified the signal.We studied the transistor in science class.