answersLogoWhite

0

What else can I help you with?

Continue Learning about Engineering

What is the difference between planar transformer and AA normal transformer?

I am currently designing a planar transformer for a switch-mode power supply. From what I understand, planar transformer is better than a normal transformer due to its shape. It utilises flat E ferrite cores and winding tracks which saves space and is more compact for a power supply. It also has lower leakage inductance which makes it more efficient.


Which is more soft phase ferrite or austenite in iron carbon diagram?

Pretty sure it is ferrite


How to measure the ferrite number?

You can measure the ferrite number of a steel using a Severn Gage, a mechanical device; or using a ferrite scope, an electronic device, available from several manufacturers.


How free ferrite can be measured in a given microstructure?

jmhhfgvbn dxv


What is the difference between ferrite bead and an inductor and On what basis they have to be selected?

Ferrite bead is a lossy inductor.When the frequency is high the Ferrite bead purely acts as a resistance so high speed noises are absorbed by the FB and it dissipate in the form of heat. Based on the current rating,cross over frequency the ferrite bead should be select ANSWER: A ferrite bead is a powder core if a line is wrapped on it that will eliminate RF signal externally injected into the line to interfere with the circuit that the line is going to it. The selection is arbitrary until it does the job. bigger the better. An inductor is also a choke to reduce RF but not as effective and it does have losses on the line

Related Questions

What is the basic Difference between ferrite core and normal transformer?

i think Transformer operates AC and ferrite core operates in DC


What is the mean of in electrical uH?

The electrical abbreviation ( UH ) is a measure of inductance , as in a ferrite transformer core , inductors , choke etc. .


What is the difference between planar transformer and AA normal transformer?

I am currently designing a planar transformer for a switch-mode power supply. From what I understand, planar transformer is better than a normal transformer due to its shape. It utilises flat E ferrite cores and winding tracks which saves space and is more compact for a power supply. It also has lower leakage inductance which makes it more efficient.


Is a tv main and power and the flyback transformer the same thing?

the main or power transformer is your iron and copper variety to get all the voltages to supply various circuitry fly back is ferrite in a resonant tank on the 15Khz to get the 10Kv for the second anode of the crt


What does t1 stand for in electrical terms?

On a schematic for an electronic circuit it usually means a transformer. T1 is the 1st transformer, T2 is the second etc. Some ferrite core wire wound inductors with more than one winding may be designated as T1.


What does T1 mean in electricity terms?

On a schematic for an electronic circuit it usually means a transformer. T1 is the 1st transformer, T2 is the second etc. Some ferrite core wire wound inductors with more than one winding may be designated as T1.


Why does a voip phone require a ferrite clamp?

Ferrite


How do I convert a Ferrite number into a percentage?

While there is no direct correlation, with higher ferrite numbers ( >30) a factor of 0.7 can be applied to produce % ferrite.


What is a ferrite clamp?

it is an accessory used when mounting a transformer that makes that the two pieces of the magnetic core remain together closing the magentic circuit, normally is a metal U shape piece which deformation guarantees fitting.


Which is more soft phase ferrite or austenite in iron carbon diagram?

Pretty sure it is ferrite


When was Zanoni Ferrite born?

Zanoni Ferrite was born in 1946, in So Paulo, SP, Brazil.


How to measure the ferrite number?

You can measure the ferrite number of a steel using a Severn Gage, a mechanical device; or using a ferrite scope, an electronic device, available from several manufacturers.