it is amount if current takes for unit diffection in given galvanometer
last year merit list of engineerinin uet lohare
yes
yes
Organizations that hire based solely on ability and skill are using merit-based methodology. The majority of equal opportunity employers are also merit based.
in 2011 the cut off rank was 203 for General Merit.
A figure of merit correlated with the energyefficiency of a device. It can be calculated by the product of propagation delay time with power dissipation.
yes
A figure of merit correlated with the energyefficiency of a device. It can be calculated by the product of propagation delay time with power dissipation.
The figure of merit is used to evaluate the performance of a sensor by considering factors like sensitivity, resolution, and noise. Current sensitivity specifically refers to the ability of a sensor to respond to changes in current. A higher figure of merit indicates better overall sensor performance, which can be influenced by the current sensitivity of the sensor.
It is the amount if current it takes for unit deflection in the given galvanometer. k = I/theta Where k is the figure of merit, I is the current supplied and Theta equals the number of divisions of deflection.
The figure of merit of a galvanometer depends on its sensitivity, which is the amount of deflection for a given current; its damping, which is how quickly the needle returns to zero position after being deflected; and its resistance, which affects the amount of current needed for deflection.
this site has not given the answer of my question
A figure of merit for copper is 231A figure of merit for stainless steel is 8.1A figure of merit for steel (mild) is 32A figure of merit for aluminum is 136.The units are BTU / H * ft * Degrees F.For a given length of time copper will conduct almost twice as much heat as aluminum and 28 times as much as stainless steel (but only about 7 times as much as regular steel). This is why there are copper bottomed stainless steel pots.From the definition of thermal conductivity: for 1 Ft cube of copper it would take 231 BTU per hour to maintain a 1 degree (Fahrenheit) temperature difference across the the length of the cube. This compares to 0.04 BTU for a 1 ft. cube of fiberglass insulation.
scientific merit
The prefix of merit is "meri-".
Order of Merit happened in 1902.
Oil or similar is used as a cooling fluid in electrical transformer, because it is electrically insulating - which water is not. The figure of merit is the lack of conductivity.