answersLogoWhite

0

What else can I help you with?

Continue Learning about Engineering

What should be the minimum distance between a TV and a voltage stabilizer?

1meter


What are the desirable properties of a cutting tools?

1. cutting tool should be more harder than the material to be cut otherwise it can break during the process. 2.cutting tool should be tough.well,there is much difference between the word hard and tough. hardness implies resistance to scratch whereas toughness measure ability to withstand shock. 3.The tool should be able to withstand the heat generated in the metal cutting process. Also, the tool must have a specific geometry, designed so that the cutting edge can contact the workpiece without the rest of the tool dragging on the surface of the piece part surface. The angle of the cutting face is also importantol must be able to withstand the heat generated in the metal cutting process. The angle of the cutting face is also important as is the flute width, tool margin and tool material. SUGGESTIONS ARE WELCOME


Why should you keep waste to a minimum and follow procedures for recycling and disposal of hazardous materials?

To save you and other from harm.


What is the fault in pipe cutters which leads to tracking or spiral cutting?

The cutting wheel is loose. Over tightening when you start can cause this. Cheap cutters do it quicker. Putting just enough pressure on the cutting wheel to make a groove until you make a couple of turns should keep the cutter lined up so that you can tighten the cutter.


What would be minimum capacity of transformer betweed generator and 220 kV transmission line system?

At a minimum, the main step up transformer for a generator should carry 105% of the full MW output of the generator.

Related Questions

In a stationary fluoroscopy machine the minimum distance acceptable between patient and fluoroscopy tube should be what?

The minimum source-to-skin distance distance for a fixed fluoroscopy unit is 15 inches. For a portable x-ray machine, the minimum distance is 12 inches.


What should be the minimum distance between a TV and a voltage stabilizer?

1meter


What minimum distance should you come near a navy vessel?

100


What are some solutions to too many trees being cut down?

we should limit our cutting to a minimum


What should be the minimum distance between a house and a neem tree?

Neem trees don't have to be too far from the house. The minimum distance would be between seven and eight feet.


What is the minimum distance the forks of a forklift truck should extend into a pallet?

Half the way


What is the minimum distance you should keep when following another forklift?

three truck lengths


What is the minimum distance that you should signal a turn?

100 ft for every 10 mph.


What is the minimum distance that should be maintained between a fireplace and a TV for safety reasons?

The minimum distance that should be maintained between a fireplace and a TV for safety reasons is typically around 3 feet to prevent overheating and potential fire hazards.


What should be the distance between the cooking range and sink on kitchen platform?

The distance between the cooking range and sink on kitchen platform should be minimum 2 feets


What is the minimum distance a non sterile person should remain from a sterile field?

10 feet


What is the minimum distance you should leave between your vehicle and the cyclist?

1 meter = 3 feet