answersLogoWhite

0

The main task is a Stabilizer Stable the boiling point of a mixer by light parts evaporation

User Avatar

Wiki User

13y ago

What else can I help you with?

Continue Learning about Engineering

What is light coker naphtha?

Coker naphtha is an intermediate hydrocarbon product of a delayed coker unit. The boiling point is closest to that of gasoline. In some cases the delayed coker unit will contain a unit operation called a naphtha splitter, in which the coker naphtha is distilled by fractional distillation into light and heavy coker naphtha. The heavy coker naphtha may be discarded back into the light coker gasoil or used as an intermediate elsewhere the in refinery. A naphtha splitter is often required when the cut point of naphtha at the refinery is "low" (approximately less than 135°C). Low naphtha cut points are the result of stringent environmental regulations. Since most of the sulfur is in the heaviest third of the total gasoline, excluding it from the gasoline blending pool may be the easiest way to comply with strict environmental regulations. In this case the higher sulfur heavy coker naphtha may be discarded as a blending component for synthetic crude oil or blending with light cycle oil (LCO).


Block diagram of hydrotreating of naphtha?

See Related Links below.


What difference between stabilizer and regulator?

in servo stabilizer voltage deviation is less(nearly+-1),in stabilizer it is +-10.The reason is in stabilizer there is only 3 or 4 out put based on input,but servo stabilizer works with servo motor therefor it will vary the out put with input through its movement over the transformer coils ,out put is taking from the contact portion of the servo motor with the generator coil.in stabilizer out put is taking from some intervals .


How do you remove a column from JTable?

ColumnModel columnModel = table.getColumnModel(); for(Column: columnModel.getColumns()) { Column column = <FIND COLUMN YOU NEED>; } columnModel.removeColumn(column);


What is a circuit diagram of a voltage stabilizer?

It's a diagram showing the components and connections needed to build a voltage stabilizer. The diagram will show a power transistor and a voltage reference, such as a zener diode.

Related Questions

What is unstabilized naphtha?

Unstabalized naphtha (also known as light naphtha) consists of the light components of a crude oil distillation which have not yet had the C4 components removed from it. Unstabalized naphtha is fed to a tall distillation column (approximately 20-30 trays) known as a debutanizer where all C4 components (and any lighter boiling point components) are removed. The bottom product of a debutanizer is stabilized naphtha.


What is the difference between naphtha Japan and naphtha mops Japan?

MOPS stands for Mean of Platts Singapore... MOPS Naphtha is Singapore Naphtha. Japan Naphtha is MOPJ Naphtha.


What is column stability?

The main task is a Stabilizer Stable the boiling point of a mixer by light parts evaporation


Describe how the naphtha fraction separates from the other fractions?

During fractional distillation of crude oil, the naphtha fraction separates because it has a lower boiling point compared to the other fractions. As the temperature in the distillation column increases, the naphtha vaporizes and rises to a level where it condenses back into liquid, forming a separate layer from the heavier fractions. This separation is based on the differences in boiling points of the components in crude oil.


What is naphtha?

can i clean sticky tape from hard pepper with naphtha


What is naphtha in rubber?

Naphtha is used as a Rubber Solvent. It is not in rubber.


What are the different types of naptha?

There are two main types of naphtha: light naphtha and heavy naphtha. Light naphtha has a lower boiling point and is used as a feedstock for the production of petrochemicals, while heavy naphtha has a higher boiling point and is used as a feedstock for gasoline production.


What is petroleum naphtha?

Naphtha is just the latin term for petrol. or Greek, not sure.


What is the density of naphtha?

The average molecular weight of naphtha is 157.5 g/mol. Each molecule of naphtha can have vastly different weight because naphtha is a mixture of many different volatile hydrocarbons.


What color is naphtha?

The colour of Naphtha is a light pink with a hint of red.


What is the specific heat of naphtha?

The Specific heat of Naphtha is 0.526 BTU/Lb F


What are harmful or long term affects of naphtha?

Oral consumption of Naphtha can lead to kidney, liver, and CNS problems. Topical exposure to Naphtha can cause a burning sensation on the skin.