answersLogoWhite

0

planer density is the ratio of number of atoms to area of plane .

User Avatar

Wiki User

12y ago

What else can I help you with?

Continue Learning about Engineering

What is the difference between a jointer and a planer?

A jointer is used for putting a straight edge on a board. A planer is used for obtaining a flat surface on the board. With a jointer, you run the board through on it's edge, and with a planer you generally run the board flat.


Explain the function of each part of the double housing planner?

PLANER MACHINEIntroduction: The planer is a machine tool designed to produce plane and flat surface on a workpiece which is too large or too heavy. The workpiece is securely fixed on a table called platen, and it reciprocates horizontally against a single edged cutting tool. The surface machined may be horizontal, vertical or at an angle.Operations of planer machine: The planer is used for:1. Planing flat horizontal, vertical and curved surfaces.2. Planing at an angle and machining dovetails.3. Planing slots and grooves.The planer are available in different types for doing different types and sizes of job; the most common being the standard and double housing planer.Construction: The main parts of the double Housing Planer machine is Bed and table, Housings, Cross rail, , Tool heads, Driving and feed mechanism.Bed and table: The bed is a long heavy base and table made of cast iron. Its top surface is flat and machined accurately. The flat top surface has slots in which the workpiece can be securely clamped. The workpiece needs rigid fixing so that it does not shift out of its position. The standard clamping devices used on planer machine are: Heavy duty vice, T-holders and clamps, angle plate, planer jack, step blocks and stop. The table movement may be actuated by a variable speed drive through a rack and pinion arrangement, or a hydraulic system.Housings: The housings are the rigid and upright column like castings. These are located near the centre on each side of the base.Cross rail: The cross rail is a horizontal member supported on the machined ways of the upright columns. Guide ways are provided on vertical face of each column and that enables up and vertical movement of the cross rail. The vertical movement of the cross rail allows to accommodate workpiece of different heights. Since the cross rail is supported at both the ends, this type of planer machine is rigid in construction.Tool heads: Generally two tool heads are mounted in the horizontal cross rail and one on each of the vertical housing. Tool heads may be swiveled so that angular cuts can be made.Driving and feed mechanism: The tool heads may be fed either by hand or by power in crosswise or vertical direction. The motor drive is usually at one side of the planer near the centre and drive mechanism is located under the table.The size of the planer is specified by the maximum length of the stroke, and also by the size of the largest rectangular solid that can be machined on it.


What are the big machines called that lay asphalt on main roads and highways?

The big machine that lays asphalt on main roads and highways is called a cold planer.


What is the density of crca sheets?

WHAT IS THE DENSITY OF CRCA WHAT IS THE DENSITY OF CRCA


Density of cement according to Indian standards?

what is cement density