The specific resisitivity - also called residual or inherent resistivity - of a particular material (scientifically called its specific resistivity) is measured in ohms per unit volume.
It can be determined by measuring the resistance of a test conductor having unit length and unit cross sectional area or some other accurately-measured volume of the material.
resistivity and resistance are two diff. things...........resistance depends on length and thickness resisitivity too depends on the area and length resistivity=resistance*area/length
10^15
I think the equation you are looking for is Resistance (ohms) = Resistivity * Length / Area or R=p*L/A. This is the resistance of a circular wire with cross-section of A, length of L, and material with resistivity p. So to get area: Area = Resistivity * Length / Resistance.
Resistivity is the resistance, in ohms, between the opposite faces of a 1-metre-cube of a material. For metals, resistivity is in the region of 0.0000001 ohm-metre. For semiconductors, it is much higher - it is in the region of 0.01 ohm-metres.
L1-L0=(RESISTANCE*AREA)/RESISTIVITY where L1=INIIAL LENGTH and L2=FINAL LENGTH
The resistivity of germanium will decrease with increasing temperature due to a positive temperature coefficient of resistivity, while the resistivity of silicon will increase with increasing temperature due to a negative temperature coefficient of resistivity. At room temperature, silicon will have a higher resistivity compared to germanium.
Resistance is due to scattering of conduction electrons. A metallic crystal can be viewed simplistically as a periodic array of ions with a cloud of delocalised conduction elections. The electrons do not scatter of the ions themselves because the crystal is periodic. There are two significant causes of scattering: 1. scattering off vibrations of the atomic lattice (phonons). This contribution to the resistivity is proportional to temperature. 2. scattering off defects in the crystal. At low temperature, this is the cause of a finite 'residual resistivity'. The two terms add linearly Rtotal = R1(T) + R2 Cold working a metal will introduce defects and thus lead to an increase in R2. Conversely, annealling the metal at high temperature will remove defects and reduce the residual resistivity.
Resistivity won't change. Resistivity is a material property that doesn't depend on the shape.
No. In fact it is the opposite. Conductivity is the reciprocal of resistivity so a high resistivity means low conductivity. peace.
There is no 'formula' for resistivity. The resistivities of different conductors have been determined by experiment.
No, resistivity cannot be negative. Resistivity is a material property that indicates how strongly a material opposes the flow of electric current. It is always a positive quantity, even though some materials may have very low resistivity values.
The resistivity of deionized water is high, meaning it is a good insulator. It is higher than the resistivity of tap water or seawater, which have more dissolved ions and conduct electricity better.
Resistivity is a measure of a material's ability to resist the flow of electric current. It depends on factors such as the material's composition, temperature, and dimensions. Materials with high resistivity impede the flow of current more than those with low resistivity.
Materials can be classified based on their resistivity as conductors, semiconductors, or insulators. Conductors have low resistivity, allowing electric current to flow easily. Semiconductors have resistivity in between conductors and insulators, and their conductivity can be controlled. Insulators have high resistivity and do not allow electric current to flow easily.
The value of resistivity of human skin is 0.2 Ohm-meters
The resistivity of Eureka is approximately 2.8 × 10^-6 ohm-meters.
The resistivity of deionized water is typically around 18.2 megaohm-cm.