answersLogoWhite

0

What else can I help you with?

Continue Learning about Engineering

What is the signal frequency if a beam sweeps across the scope 100 times per second and there are 6 cycles on the face of the scope?

The beam is tracing 6 cycles 100 times per second,so the signal frequency is (6 x 100) = 600 Hz.


What is the frequency scaling technique in filters?

Frequency scaling in filters is a technique used to adjust the frequency response of a filter by altering the frequency components of the input signal. This can involve multiplying the frequency values by a scaling factor, which effectively stretches or compresses the frequency spectrum. As a result, the filter can be adapted to different applications without redesigning the filter itself, allowing for greater flexibility in signal processing tasks. This technique is commonly applied in digital signal processing to create filters with desired characteristics.


List two differences between information signal and carrier signal.?

A: A carrier carry information by modulation either Amplitude or Frequency modulation. Therefore AM and FM RADIO M stand for modulation


Two signals of 2GHz and 4GHz are frequency modulated on same carrier 10?

Definition: In FM technique, the frequency of the carrier signal changes according to the instantaneous amplitude of the modulating signal. Hence, the frequency of the modulating signal is of irrelevance here and the devition from "fc" will be dependent on the amplitude of the same. considering 2GHz and 4GHz to be digital signal the ratio would be 1:1.


What is difference between injection rate and injection pressure?

The injection rate is the number of injections. The injection pressure is the pressure the injection is under.

Related Questions

What is a ray tracing?

A mathematical technique which involves tracing theoretical rays of light within a mathematically defined world. Render-Boy uses this technique to render images.


What is ray tracing?

A mathematical technique which involves tracing theoretical rays of light within a mathematically defined world. Render-Boy uses this technique to render images.


What is tracing vellum?

Tracing vellum is often used for experimenting on top of a pencil drawing, prior to committing a technique to the final page.


Tc ignition injection cut off bad signal?

ıgnition injection cutoff bad


Which is more fuel system technique Multi Point Fuel Injection or sequential electronic fuel injection?

kgjhbv


What is the name of the technique that uses color intensity to add realism to a three dimensional object?

ray tracing


What manufacturing technique is used to create the unique foamposite upper?

Injection mold


The smog technique stands for signal over the shoulder?

Signal Mirror Over your shoulder Go


Which synchronous technique requires the most bandwidth?

Seperate clock signal


When will a V wave be seen on the normal EKG tracing?

Yes, a V wave will be seen on a normal EKG tracing. A V wave can signal a lot of things in an EKG, but what it means will be up to the person reading the EKG and the person's reason for the EKG.


Why does it burn so bad after testosterone injection?

The burning sensation after a testosterone injection can occur due to several factors, including the viscosity of the oil used as a carrier, the injection technique, or irritation of the tissue at the injection site. Some formulations contain alcohol or other additives that may cause discomfort. Additionally, if the injection is not administered properly or if the needle is too large, it can lead to more trauma in the muscle, resulting in pain. Proper technique and using the right needle size can help minimize this discomfort.


Why in some cases does the injection make you bleed?

Bleeding at the injection site can occur due to several reasons, such as puncturing a blood vessel during the injection. Additionally, certain medications or vaccines may have anticoagulant effects that make bleeding more likely. Individual factors like skin sensitivity, the technique used, and the size of the needle can also contribute to bleeding. Proper technique and pressure applied after the injection can help minimize this risk.