Electrical resistivity is a measure of how a material opposes the flow of electric current. Copper is used for electrical lines because it has a low resistance relative to its cost. Gold and silver also have a low resistance, but imagine how expensive the power cord for your computer would be if it were made of gold!
resistivity and resistance are two diff. things...........resistance depends on length and thickness resisitivity too depends on the area and length resistivity=resistance*area/length
Resistance of a conductor is defined by the specific resistivity, area of cross section and the length of the conductor. R = rL/A, where R is resistance in OHMs, r is specific resistance, L length in mm, A is area of cross section in sq mm
You can use a multi-meter to measure resistance. The specific portion of the meter for measuring resistance is called an ohmmeter.
For a specific voltage, current flow is inversely proportional to resistance.
Cell constant(C) = Resistance(R) X Specific Conductivity(K)
Nichrome has a high electrical resistivity.
resistivity and resistance are two diff. things...........resistance depends on length and thickness resisitivity too depends on the area and length resistivity=resistance*area/length
It was not a specific event. Resistance appeared where there was oppression.
No, higher specific resistance means lower conductivity. Specific resistance is the resistance of a material per unit length and cross-sectional area, so a higher value indicates that the material resists the flow of electric current more effectively. Conversely, materials with lower specific resistance values are more conductive.
It means Different songs in different regions . In diff places have diff folks .
More information is needed as to what your terminology of D insulation is.
1/specific resistance
The specific resistance of pure silicon is around 2300 ohm-cm at room temperature.
Resistance of a conductor is defined by the specific resistivity, area of cross section and the length of the conductor. R = rL/A, where R is resistance in OHMs, r is specific resistance, L length in mm, A is area of cross section in sq mm
Diff is short for difference.
High input impedance implements the operation of the external feedback circuitry (e.g. diff. amplifiers vs. comparators).
The specific resistance of rubber depends on its composition and properties. However, it typically ranges from 10^10 to 10^16 ohm-meter.