Apart from anything else, it's necessary to know the rated votage of the pump!
You need to know the amperage requirement of the pump and then you can calculate the wire size.
To answer this question the size of the cable or the amperage of the load is needed to calculate the correct wire size and connectors to fit the cable.
The cable size is : 4*25 mm2
6mm cable
There is actually no specific formula used to work out cable size. In order to determine the type of cable you need and the size you need, you need to know the source of the supply, the voltage of the system, the ambient temperature, and the method you plan on laying out the cable.
Depth to lower water level
Each pump is different, but you should get somewhere about 6000 gph
You need to know the amperage requirement of the pump and then you can calculate the wire size.
12/2 with ground.
A 2hp submersible pump typically has a power rating of 2 horsepower, allowing it to efficiently pump water from underground sources. It is designed to be submerged in water, making it suitable for applications such as well pumping and drainage. These pumps are usually made of durable materials like stainless steel and have a maximum flow rate and head pressure that can vary depending on the specific model.
The magneto point gap on a 2hp Yamaha outboard is 0.35mm, or 0.014".
Find the amperage that your pump motor operates on (should be on the motor nameplate) and multiply it by the voltage that the motor is connected to (120 or 240 volts). This will give you the wattage of the motor. It is usage of watts that the utility company bills you on. Find from your utility bill what you are charged per kilowatt hour. Take your pump wattage, times the amount of time that the pump runs, times the kilowatt rate you are charged by the utility company and the result will be how much it costs you to run the pump motor.
If you have replaced the pump with a bigger pump without changing the filtration it is to be expected that the pressure will go up because the pump is trying to push more water through the same area..
To answer this question the size of the cable or the amperage of the load is needed to calculate the correct wire size and connectors to fit the cable.
4cx95mm aws which size of cable gland
No. At least a 2Hp pump here. Also be sure your filter is large enough to handle the flow rate. Yes it will, provided that you let it run long enough and your plumbing is not too convoluted and your filter is large enough. You only need to get 17GPM, if you run the pump 24 hours a day. Most 1HP pumps these days can easily do that, even with 60 feet of head. If you plan on running solar pannels on a roof, then you will need 2HP.
We have a 24' foot round above ground with 13000.00 gallons of water and that only requires a 1 hp pump a 2 hp pump may be overkill and cost more to operate