The current varies but a rule of thumb is to allow 7 amps per horse power on 240 v, that means 7.64 amps on 220v, which 1.68 kVA.
1 horse-power is 746 watts, and with a conversion efficiency of 0.85 the power drawn is 880 watts on full load.
the current carrying capacity of 16sq.mm copper conductor is as below: For Single phase A.C or D.C is - 76 amperes (VIR insulated) and that For Three phase A.C or D.C is - 66 amperes. (rubber insulated)
5
Continouous safe current carrying capacity for following conditions for a single cablea) Ground tempreture.b) Thermal resistivity of soil 120 C Cm /wc) Depth of laying in 1070 mm. 25 sq mm&95 sq mm p v c insulated cable 1.1 k v
Split Phase Induction Motor.
It measures current flow in amps or milliamps. It needs to be in series with the current flow or in the case of a clamp-on meter it must encircle the single conductor carrying current.
64 AMPS
Bundled conductors have a higher current carrying capacity compared to a single conductor of the same total cross-sectional area, due to improved heat dissipation. This is because the proximity of the conductors allows for more efficient cooling and reduces the overall resistance.
Current carrying capacity is different for aluminum from that of copper cable. Under different conditions like, type of insulation, number of conductors, in conduit, underground, in air, single or multilayer, system voltage, the current carrying capacity varies a bit. Hence You must refer a standard chart from a reputed cable company.
False
Lester Eugene Stutz has written: 'The design of an induction motor, single phase double current generator set' -- subject(s): Electric motors, Induction, Induction Electric motors
1 GB (Gigabyte)
the current carrying capacity of 16sq.mm copper conductor is as below: For Single phase A.C or D.C is - 76 amperes (VIR insulated) and that For Three phase A.C or D.C is - 66 amperes. (rubber insulated)
to start the motor and give more current to motor to run
An amp meter measures current flow, not power. An amp meter measures instantaneous current either by being inserted in series with the wire being measured for current flow, or clamped onto a single current carrying wire and measuring current flow by induction. If the load is disconnected then no current will flow and the amp meter will read zero.CommentThe correct term is ammeter, not 'amp meter'.
5
AS PER THUMB RULE THE CURRENT CARRYING CAPACITY OF WIRE IS 4 TIMES OF ITS CROSSECTIONAL AREA OF WIRE i.e. 10 sq.mm wire carrying maximum current 40 amp , 16 sq.mm carrying maximum current 64 amp , now amp convert in watt by multiplying by volt i.e. 240 16 sq.mm carrying max load 64x240= 15360 watt
Continouous safe current carrying capacity for following conditions for a single cablea) Ground tempreture.b) Thermal resistivity of soil 120 C Cm /wc) Depth of laying in 1070 mm. 25 sq mm&95 sq mm p v c insulated cable 1.1 k v