The main different between a traditional signal and a message is their recipient. A signal is often sent to a mass of people, while a message is more individualized.
processing is nothing
Distortion.
A phase difference between two periodic signals is the time difference between two corresponding points on each signal. This time difference is usually measured in degrees or radians, but can be given as a unit of time as well.
Signal to noise ratio is the difference between the noise floor and the reference level.
Each step in a cascade produces a large number of activated products, causing signal amplification as the cascade progresses.
in transition the states are changed from one state to another but in event the signals are changed or trigered with respect to that signal.
The main difference between the tow is the signal. VGA uses an analog signal and DVI is a digital signal.
processing is nothing
wave is a part of a signal . millions of wave construct a signal .
Distortion.
the same
The basic difference is that in analog modulation the modulating signal is analog signal and in digital modulation it is in digital form.
this is not the way to question me when i question you ..... and the major difference between event and method is that event starts with alphabet E and method starts with alphabet M ok.....
SINR - Signal to Interference and Noise Ratio CINR - Carrier to Interference and Noise Ratio difference between those to is difference between carrier and signal carrier is signal who doesn't "carry" any information . it must be modulated( by phase,freq or amplitude) and those changes convey information. carrier is unmodulated signal signal is defined as useful signal which carries information SINR is power of signal to power of interfenence and noise ratio
It is more LIKELY to have a likely event than a UNLIKELY event.
event organizer - organises an event venue - is where an event is planned to occur
the difference between both are: Primary transducer:The Mechanical device which converts physical quantity to be measured into a mechanical signal. Secondary tranducer:The Electrical device which converts this mechanical signal to the electrical signal.