answersLogoWhite

0

What else can I help you with?

Continue Learning about Engineering

What should be the value of capacitor at transistor amplifier circuit input?

at full input, if the transistor is working, the value of capacitor will be 0.


Why initially capacitor taking more current?

Consider the instantaneous DC analysis. Initially, the capacitor has zero resistance. You apply a voltage and current is controlled by other resistive elements alone. As the capacitor charges, its effective resistance rises. This adds to the net resistance in the circuit, reducing current. At full charge, the capacitor has infinite resistance, so there is no current. Remember that the equation for a capacitor is dv/dt = i/c.


What is run capacitor in single phase motor starter with three wire?

A run capacitor and a starter capacitor are not the same thing. A run capacitor is energized the entire time the motor is running, and a start capacitor is not. A run capacitor is one that changes the current on the windings of a single phase AC induction motor to create a rotating magnetic field to energize a second-phase winding. A start capacitor increases starting torque, allowing a motor to be turned on rapidly. It stays in the circuit only long enough to bring the motor to 3/4 of full speed. Some motors then continue to run with a run capacitor.


What is the function of capacitor in full wave rectifier with smoothing capacitor circuit?

is a device that smoothen your half-wave rectification into a full-wave rectification after using a 4 diode and 1 resistor , after adding a capacitor , there will be a almost steady output , it charges the capacitor when is forward biased which is the first half wave , and discharge when is reverse biased to stablelize the wave into a almost same potential difference compare to a.c


A 10 microfard capacitor is charged through a 10 ohm resistor. How long will it take for the capacitor t fully charge?

If a 10 microfarad capacitor is charged through a 10 ohm resistor, it will theoretically never reach full charge. Practically, however, it can be considered fully charged after 5 time constants. One time constant is farads times ohms, so the time constant for a 10 microfarad capacitor and a 10 ohm resistor is 100 microseconds. Full charge will be about 500 microseconds.