selection of q-point is necessary in amplifiers,because if the q-point is not in the middle of load line the output may be clipped i.e not in the power supply range.
It helps us to select the Q - point of the BJT, MOSFET etc.
the higher the q the sharper is the response however if drift occurs the it will be in-out because of it
the fixed amount of current and voltages are developed across the transistor is called biasing. thus the fixed voltages and current developed are called Q-point
to establish Q- point or operating point...
Biasing of the transistor is responsible for stability of Q point.
It helps us to select the Q - point of the BJT, MOSFET etc.
the higher the q the sharper is the response however if drift occurs the it will be in-out because of it
Q
Q-point means motionless point. At operating point the transistor emitter current and collector current doesn't change. That is why operating called as a quiesent point (q-point)
depending on the graph where point Q was you would not be able to tell where point Q ended after the rotaion finshed
If (p, q) is any point on the line, then the point slope equation is: (y - q)/(x - p) = 2 or (y - q) = 2*(x - p)
Q point is also called operating point.Q point is mainly adjusted in transistors to make it stable. i.e., to operate the transistor in safe mode. Depending up on the operating current and voltage Q point is adjusted. The Q point defines the operating condition of the transistor and the transistors which quiescent point is adjusted are denoted as Q1,Q2.........Qn
Stabity factor is not a circuit.It is a parameter,which decides the ability of Biasing circuits,to keep the Q-pt stable in the center of DCLoadLINE.It should be as low as possible
Q point is also called operating point.Q point is mainly adjusted in transistors to make it stable. i.e., to operate the transistor in safe mode. Depending up on the operating current and voltage Q point is adjusted. The Q point defines the operating condition of the transistor and the transistors which quiescent point is adjusted are denoted as Q1,Q2.........Qn
· queen
Point S
Q point which is quiscent (silent) point is the operating point of a transistor where the variations of collector current and collector-emitter voltage take place when signal is applied.