No. If the load requires 168 W, then an 84 W inverter is not going to maintain the load.
You probably mean "... where there should be a DC output ?",and the answer is "No. They don't work in reverse.".
You do not need to use an external variable frequency drive for the said AC. You have mentioned that it is inverter AC. It means the AC is already fitted with a built in inverter. Even if you connect an inverter to the AC, you need another control device to control the VFD to control the speed of the fan/ compressor depending upon the room condition, external temperature, temperature setting etc. It is little complicated.
the z-source inverter use an input diode and x-shape network of capacitors and inductor
the z-source inverter use an input diode and x-shape network of capacitors and inductor
USE INVERTER USE INVERTER USE INVERTER
Yes, you can use an inverter to power a 12V winch, but keep in mind that the inverter's voltage output should match the winch's voltage requirement. Additionally, make sure the inverter's wattage capacity can handle the power draw of the winch to prevent overheating or malfunction.
To answer this question have to know the voltage you are using.
Use a mosfet driver instead of a simple resistor. Using a resistor to control the mosfet is a bad idea anyways because you will have terrible control (mosfets are voltage controlled. Take a look at the response curve for your mosfet). If your mosfet is fully on, its ratings may be too low for continuous operation or the power dissipation is too low for the transition between off an on an that is killing your mosfet.
No. If the load requires 168 W, then an 84 W inverter is not going to maintain the load.
You can use a frequency converter to change the output frequency of the inverter from 60Hz to 50Hz. This will allow you to use devices that are rated for 50Hz frequency with your 110V 60Hz inverter. Just make sure to select a frequency converter that is compatible with the power output of your inverter.
You probably mean "... where there should be a DC output ?",and the answer is "No. They don't work in reverse.".
The inverter should supply at least 1 kW and if it is for extended use more than 4-5 minutes it should supply 1.5 kW.
Provided the heater is of a low wattage it should not affect normal running of the car
not yet
2 hours. 500watt x 1 hour = .5kwh
i want to use this type of inverter for my project.