2" minimum.
Most of the time it is 4 inch.
Depends on the mateiral you already have (PVC) Galvanized nippe and brass P trap or rough brass connectiong to the trap and then of course what size of drain basin, KS, Slop Sink
Could be a drain for the inducer motor if it has one and it depends do you have a a/c coil on your furnace if so it could be a drain for it.
Abs to PVC glue sold at home depot Color it aqua blue/green plumbers key term. GUMBY GLUE Depends upon what you mean by "black pipe". If you mean ABS drain pipe, there is glue for that. If you mean steel "black pipe", i.e., non-galvanized, then you would need a threaded connection adapted to the PVC (either a female PVC connector on a male black pipe or a male PVC connector into a female black pipe fitting). The secondary question would be, "Why would anyone want do to that?"
I can't imagine the plumber only giving 1 year on the PVC. Cast iron is rough on the inside and those rought spots can snag paper, lint, etc, eventually leading to blockage. PVC should last much longer and be less susceptible to blockages from material getting caught on the inside wall of the pipes. Also, PVC doesn't rust, while cast iron will. All-in-all, I'd have to vote for the PVC (make sure that it is at least Schedule 40 PVC).
You can extend the washing machine drain hose by using a hose extension kit or a simple PVC pipe. Make sure to secure the connection properly to prevent leaks and ensure the hose reaches the drain outlet without any kinks or bends.
To properly install a washing machine drain pan, follow these steps: Place the drain pan in the desired location, ensuring it is level. Connect the drain pan to the existing drain pipe using a PVC connector. Secure the drain pan in place using screws or adhesive. Test the drain pan by pouring water into it to check for leaks. Adjust as needed to ensure proper drainage and functionality.
no 2" is enough if it's just the washing machine.
The different types of washing machine connectors available in the market include braided stainless steel hoses, rubber hoses, and PVC hoses.
Yes, if they are the proper size to mate, or match up. yes
Most of the time it is 4 inch.
If the toilet and shower are in an upper floor then there is a PVC drain for both that will drain to either the sewer or septic. If there is a vertical piece to this, as there is in my basement, then you actually get some dribbling and running sounds from the water 'falling' down that vertical PVC. I get this same noise from the washing machine on the main floor draining down to the basement.
Probably the wrong size flange. Is the flange a toilet collar? If so the pipe is probably 4 inch.
Yes
Use PVC for the drain line. It does not require insulation.
The best method for installing a PVC shower drain in a bathroom renovation project is to carefully measure and cut the PVC pipe to fit the drain opening, apply PVC primer and cement to the pipe and fittings, and securely connect them together. Make sure the drain is level and properly sealed to prevent leaks.
Yes, but PVC creates problems