3 or 4 inch
The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
The drain from the toilet to the main drain is plugged and the branch to the shower is not. If the main floor toilet flushes, it is between the two toilets and not between the house and the sewer.
To size a toilet siphon, you need to consider the dimensions of the toilet bowl and the design of the siphon itself. Measure the diameter of the toilet's drain outlet and match it with the siphon's outlet size, ensuring it provides adequate flow without causing clogs. Additionally, assess the siphon's height and overall design to ensure it fits within the toilet tank while allowing for proper flushing performance. Always refer to manufacturer specifications for compatibility with specific toilet models.
It's not the toilet, there's a blockage in the pipes some where after the drain pipe from the toilet joins up with the drain pipe from the tub.You're going to need to have the pipe snaked.
partially clogged drain or vent, improperly installed vent or drain
If the drain is adequate size, 3inch, then you could.
The trap is built into the toilet itself, you shouldn't put one in the drain.
At least 3 in. drain pipe
Any vent is usually the size of the drain or waste pipe it is connected to. 3 or 4 inch on a toilet.
depends on the size of drain piping. Most toilet either have a 3" or 4" drain. The size hole needed would be larger than the outside diameter of the piping. 3" pipe=4" hole / 4" pipe=5" hole
Usually toilet flange is glued down onto plastic drain pipe. There is a toilet flange that can be glued inside of plastic drain pipe also.
The dimensions required for installing a Toto 10-inch rough-in toilet are typically a minimum of 10 inches from the wall to the center of the drain pipe. This measurement ensures proper alignment and fit for the toilet installation.
Yes as long as the drain has a trap and is vented
For a standard toilet installation, it is recommended to use a wax ring that is a standard size of 3 or 4 inches in diameter. This will help create a proper seal between the toilet and the floor drain.
To effectively unclog a toilet drain using a toilet drain auger, first insert the auger into the drain until you feel resistance. Then, rotate the handle clockwise to break up the clog. Continue to push and twist the auger until the clog is cleared. Finally, flush the toilet to ensure the drain is unclogged.
The standard measurement for a toilet drain rough-in is 12 inches from the finished wall to the center of the drain.
The purpose of a toilet drain flange is to connect the toilet to the floor drain pipe. It provides a secure and stable base for the toilet to be installed on, ensuring a proper seal and preventing leaks. The flange also helps to align the toilet properly with the drain pipe, allowing for efficient and effective waste removal. Overall, the drain flange is essential for the proper installation and function of a toilet.