answersLogoWhite

0

When 'dissimilar' metals touch, they can create one of the prerequisites for galvanic corrosion.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

When was Corrosion - Front Line Assembly album - created?

Corrosion - Front Line Assembly album - was created in 1988.


What does Jack do before he leaves the assembly?

He places the conch carefully on the log.


Why is the blower not working for the heater?

Check the blower motor electric wiring connector assembly for corrosion, if OK , remove the resistor assembly and check for corrosion. If the heater core has rupture there will be some coolant getting into the assembly which over time will corrode the assembly. Te connector itself could be so badly corroded that the power has been interrupted and the possibility of fire or melting of the connector is there. I had to purchase a new connector and resistor assembly and splice the connector to remaining wiring. Hope it helps.


What type of patio screws are recommended for outdoor furniture assembly?

Stainless steel screws are recommended for outdoor furniture assembly due to their resistance to rust and corrosion in outdoor environments.


In the book lord of the flies what does Jack do before he leaves the assembly?

Before jack leaves the assembly jack places the conch carefully on the log.


How is an assembly line workers job important?

An assembly lines workers job is important because if we didnt have assembly line workers how would we get out cars and other inventions built?


How do you remove the rear wiper assembly on a dodge nitro?

Take the screws out CAREFULLY as well as the blade and swap them.


What is jacks 1st important announcement at the assembly?

The first important announcement that Jack makes at the assembly is that he is a hunter. He wants others to join him to hunt.


How do you take headlight assembly out of 97 lumina?

Look in the Owner's Manual. Considering that it's GM they have surprisingly clear instructions for changing bulbs to removing grill to R&R headlight assembly.


Why is the freedom of assembly important?

because i am gay


How do you replace tailight lens on new beetle?

The entire assembly comes out of the car. You have to VERY CAREFULLY with a screw driver pop the clips that hold it in the car. Put the screwdriver under the rubber ring on the outside of the light and carefully pry out. There are 2 or 3 located around the light. Once the light assembly pops out, you can get to the bulb. You will hear the assembly pop back into place when you put it back in.


How do you remove the tail light assembly mini cooper 2005?

To remove the tail light assembly on a 2005 Mini Cooper, first, open the trunk and locate the access panel behind the tail light. Remove any screws or clips securing the panel, then carefully pull it away to expose the tail light assembly. Disconnect the wiring harness by pressing the release tab and gently pulling it off. Finally, remove the screws holding the tail light assembly in place, then carefully pull the assembly out of the housing.