A plumber.
"Best" is a matter of opinion. The "best" water pressure is one that allows you to use the lowest possible pressure to allow proper function of all your fixtures. This reduces the stress on all of the pipes, fittings, fixtures, and appliances that require water. Typical residential water pressure runs between 30psi and 80psi.
om a fixtures are the screws
Using copper water pipes can help reduce the risk of lead contamination, but it does not guarantee that household water is completely free from lead. Lead can still enter the water supply through older plumbing fixtures, lead solder, or service lines. It's important to test your water for lead and consider additional measures, such as using lead-free fixtures and filters, to ensure water safety. Regular maintenance and monitoring are key to ensuring clean drinking water.
no they are not
In the U.S. they are called plumbers, assuming you mean water pipes, and not the pipes that one smokes.
A plumber is a person who installs and repairs pipes, fixtures, and appliances.
A plumber installs water pipes.
To replace bathtub fixtures in your bathroom, first turn off the water supply. Remove the old fixtures by unscrewing them and disconnecting any pipes. Install the new fixtures by following the manufacturer's instructions. Secure them in place and reconnect the pipes. Turn the water supply back on and test the new fixtures for leaks.
Related to water systems, it is usually a plumber.
In plumbing, a nipple is a short piece of pipe with threads on both ends. It is used to connect two fittings or fixtures together. Nipples are commonly used in plumbing installations to extend or connect pipes and fixtures in a tight space.
Lead
One that installs or repairs equipment (such as steam pipes) for heating, ventilating, or refrigerating systems
No. Plumbing rough in refers to the installation of pipes and fitting to the fixtures, not the installation of the fixtures themselves. That is called plumbing trim.
Plumbers putty typically lasts for several years when used for sealing pipes and fixtures. It is important to regularly check for any signs of wear or deterioration to ensure a proper seal.
A person who fits and repairs pipes and fixtures for water,drainage or gas systems.
A house plumbing drain diagram typically includes the layout of pipes and fixtures that carry wastewater away from sinks, toilets, showers, and other plumbing fixtures. It shows how the pipes are connected and where they lead to, such as the main sewer line or septic tank.
The recommended layout for a basement bathroom plumbing includes placing the fixtures like the toilet, sink, and shower in close proximity to each other to minimize the length of pipes. The main sewer line should be located below the fixtures for efficient drainage. Additionally, it is important to ensure proper ventilation and access for maintenance.