MCC panel is the bunch of motor feeders from where you can control power to connected motors, that's why it is called Motor Control Centre. PCC ( Power control centre), comprises of HT breaker's which controls power to transformers/ MCC's/ HT motors.
there is a possibility that parts of motor windings has partial damage.
you are beautiful just your bald head just makes Aaron want to hug you. By Aaron Albert
It is overloaded. take the motor loose and see if it runs normally if its on a machine that used to work check bearings misalignment bent shafts
Cause 2 phase is applied to the motor and another phase is disconnected ... in this condition ur motor cannot run longer ,it will trip on over current or burn ur motor winding .
lrc miss west
LRC Leerdam was created in 1958.
Learning Resources Center
LT motor abbrevation
ht motor is to be fed with more than 415v like in kvolts. all the other operated below 415 volts are lt motors
high tenssion motors
110% of the rated current.
The address of the Nicolet Area Technical College Lrc Gallery is: , Rhinelander, WI 54501
to test ht lead with out taking it out of coil pack. All you have to do is remove the 1 cylinder ht lead and pull the cylinder 5 ht lead out aswell and measure the resistance with multi meter. so now it will give you the reading. so its 1,5---2,6---3,4 ht leads.
The phone number of the Nicolet Area Technical College Lrc Gallery is: 715-365-4556.
on the cab side of the motor. Just follow the ht leads!!
MCC panel is the bunch of motor feeders from where you can control power to connected motors, that's why it is called Motor Control Centre. PCC ( Power control centre), comprises of HT breaker's which controls power to transformers/ MCC's/ HT motors.