to calculate and measure the impedance ,admittance is simple
Two reasons. 1...When impedance of source and destination match, power transfer is maximum. 2...If a long transmission line is involved, the characteristic impedance of the line must match the destination impedance, or reflections will occur on the line.
That depends on the output impedance. In electronic we use voltage bridging, that is a relative low output impedance to a higher input impedance. Usualy the input impedance is more than ten times higher then the output impedance. An input impedance is called also a load impedance or an external impedance. An output impedance is called also a source impedance or an internal impedance.
The characteristic impedance or surge impedance belongs to uniform transmission lines.In electronic gears we use voltage bridging, that is a relative low output impedance to a higher input impedance. Usualy the input impedance is more than ten times higher then the output impedance.An input impedance is called also a load impedance or an external impedance.An output impedance is called also a source impedance or an internal impedance.
In electronic gears we use voltage bridging, that is a relative low output impedance to a higher input impedance. Usualy the input impedance is more than ten times higher then the output impedance.An input impedance is called also a load impedance or an external impedance.An output impedance is called also a source impedance or an internal impedance.
To calculate the admittance if you are given the impedance, you take the inverse of the impedance ( that is 1/z).
1) A normalized load admittance of (0.2 + j0.2) needs a single stub tuner. i) how far down the line should it be located? ii) what is normalized admittance at the point just to right of where stub should be attached? 2) A certain point along a transmission line the normalized admittance is (1+j1.5) i) Design the short-circuited stub necessary to change the normalized admittance to (1+j0) I would prefer the use and explanation of a smith chart. If you want to solve analitically feel free to do so.
The ratio of apparent power to true power is called 'admittance', expressed in siemens. Admittance is the inverse of impedance.
OFFSET IMPEDANCE RELAYOffset impedance relay is also known under names ADMITTANCE RELAY or MHO RELAY
to calculate and measure the impedance ,admittance is simple
Admittance is the reciprocal of impedance (1/Z) and is the vector sum of conductance (1/R) and susceptance (1/X). Admittance is used in solving parallel alternating-current circuits, because it avoids the need to vectorially add or subtract reciprocals, which would be the case if we were to use impedance, resistance, and reactance.
A siemens is a unit of conductance or admittance, expressed as the reciprocal of resistance or impedance. (Siemens = 1/ohms) One microsiemens is 1 megohm.
Two reasons. 1...When impedance of source and destination match, power transfer is maximum. 2...If a long transmission line is involved, the characteristic impedance of the line must match the destination impedance, or reflections will occur on the line.
He was refused admittance to the club.His admittance was a shock to the courtroom.
The cost of admittance into the Comic Con was 10 dollars. This is an example of admittance.
Ybus, or the bus admittance matrix, is a key component in power system analysis, particularly for load flow studies. It represents the admittance (the inverse of impedance) of the network components connected to each bus in a power system, allowing for the calculation of currents and voltages at various points. Each element of the matrix reflects the admittance between buses, accounting for both line and transformer characteristics. Ybus is essential for analyzing the performance and stability of electrical networks.
Admittance is the act of admitting or permission to enter.