Opening a radiator cap while the engine is still hot is dangerous because the pressurized coolant can erupt and cause severe burns or scalding. As the engine heats up, the pressure inside the cooling system increases significantly, and releasing that pressure suddenly can lead to a violent spray of hot coolant. Additionally, the sudden change in pressure can damage the radiator or other components. It's always best to allow the engine to cool down before attempting to open the radiator cap.
While many experimental forms of flight exist, so far the jet engine does not look like it will be replaced any time soon. Alternates to air travel also exist, but are less widely used, and frequently more dangerous, time consuming, and less efficient. For the time being, the jet engine is here to stay.
I assume you are talking about removing trapped air from the cooling system. Park uphill or jack up the front of the vehicle. Remove the radiator cap, turn heater control to hot, and start the engine. Keep the coolant level full, while the engine runs. Watch for air bubbles escaping from the radiator. When you see none, all the air is purged. It may also have a Schroeder valve somewhere on the cooling system at the highest point that can be used to purge air.
Ethylene glycol mixed up to 50% with water, lowers the freezing point of the mixture, while remaining an excellent heat transfer medium. It protects the engine from either freezing or from overheating.
Charles Babbage began designing plans for the Difference Engine in 1821 while he was a student at Cambridge University. His work on the engine aimed to automate the process of calculating mathematical tables and laid the groundwork for modern computing. Although he never completed the full machine, his concepts were pioneering and influential in the field of computation.
For heavy loads, front engine is pulling while back engine is pushing.
NO! That would be dangerous. Cars' coolant systems are pressurized, so if you open the radiator cap while the engine is running, it will spray HOT radiator fluid (water mixed with ethylene glycol, usually) all over you, and sometimes drain the radiator of coolant.
A radiator cap should never be opened when the engine is warm or especially hot!The specific steps for your vehicle type may then instruct you to start the car with the cap off and run the engine while filling, but never open the radiator when hot.Reason: the cooling system builds up pressure as the engine warms, and removing the cap while pressurized will create a dangerous geyser of coolant.
It can. You should leave the engine running while you add water to the radiator. If you add water with the engine turned off, but while the engine is overheated, you might damage the engine or the radiator.
have the engine timing checked. if the timing is wrong the engine will overheat, are you loosing coolant?is the fan working, is the water pump working?
more than likely you need a new radiator for it, when you install it back flush the engine.
While your car is running the engine is heating up. While your driving you have air being forced over the radiator cooling it off. When you are sitting still you don't have that air so your engine is heating up even more so the cooling fan comes on to help cool you engine off. Via cooling the radiator.
A hole in the radiator would do that, or a damaged radiator cap. It could be a cracked engine block that is allowing cylinder pressure into the cooling system, pressurizing the water until it breaks through a weak spot in the radiator.
On most cars if they don't have a radiator cap, then you can put it in the cooling system by pouring it in through the upper radiator hose. Even if you are suppose to do this while engine is hot DO NOT because it will have the same affect as pulling the radiator cap while hot.
No, an intercooler does not replace a radiator. While both help cool air or fluid in a vehicle, they serve different purposes. The intercooler cools compressed air from the turbocharger or supercharger before it enters the engine, while the radiator cools the engine coolant to prevent overheating.
sounds like a hole in your radiator or hoses.
It is probley just the engine coolant burning that ran into the exhaust and muffler. Just let it run awhile and burn it out. If it don't stop steaming after about 30 mins. Then you have done something wrong when putting it back together. Are you changed the wrong head. Start the engine with the radiator cap left off and keep watching in the rad while the engine is running, there should be no bubbling coming from the radiator. If there is then you still have a bad head are head gasket. Radiator should build NO pressure in it while the engine is running.
Your Lumina 2001 engine light might come on while the radiator fan is working because the fan is turning too slowly, is damaged, or is not cooling the engine correctly.