computer says no
A crown of a sewer refers to the highest point of the internal surface of a sewer pipe. It is the portion where water flows and is typically located at the top of the pipe's arch or curve. The crown is designed to facilitate the smooth flow of wastewater or stormwater.
Granted that the force was enough to crack the pipe, it would crack in the middle.
The Buchholz relay is installed in an inclined position because of buoyancy. Slightly inclined so the gas bubbles will flow to the cover and then to the Buchholz relay and not stay in a pipe corner.
Yes, but usually not. Birds nest or beehive inside or over top of vent pipe for example would clog vent.
Most of the time, when the engine is cool (not warm or hot), it should be filled to the line indicated on the over-flow tank. The anti-freeze over-flow tank is located on the passenger side with a large round top.
adjust the floating bulb, it may be running over the top of the overflow pipe
the top hose on top of the tank is to allow any overfill to escape. Any fluid will just flow from the hose fitting and down the side of the tank.
There is a 4" hole for the inlet near the top of every properly made septic tank. You connect the drain to this by gluing if it's a plastic pipe or by a 'Robar' joint if it's a cast iron pipe.
a light source that is self generating is a water tank with a recirculating pipe from the bottom to the top with a turbine transformer in the pipe
Usually on the top, on the incoming cold pipe.
computer says no
you probably mean the the over flow bottle. that is located on the drivers side front engine compartment on the very top.
From top of fuel tank connect hose to top carburetor connection> Larger pipe. from bottom of carb [smaller outlet pipe connect hose to primer pump in. From out of primer pump connect to return hose to lower tank connection.
In the side closest to the house, about 6 to 10 inches below the top of the tank, should have an elbow pointing down which may clog and should have a small access hole or plate above it in the top of the tank. Does that help?
yes you can put a glass sheet over the top of a tank to act as a lid.
The obvert elevation of a pipe is the elevation of the inner top surface of the pipe (as opposed to "invert" which is the inner bottom surface of the pipe). Invert (and obvert) is usually used in reference to pipe and not manholes, since the invert elevation is where the water flow calculations begin. Based on this interpretation, the obvert (at a manhole) can be measured as the distance from the manhole rim to the inside top of the pipe(s).