It can't
It is due to pressure rising due to a bad condenser fan motor, bad capacitor, obstructing of airflowat the condenser, or a dirty condnser.
water as a coolant
Air cooled water cooled oil cooled Totally enclosed fan cooled Refrigerant cooled
condensr is a heat exchanger which uses a medium such as air or water passin thru so that the hot refrigerant is cooled into liquid to an extent after which it can be passed thru the expansion valve to achieve the desired cooling effect. it gives an initial drop in temp at constant pressure and a change of phase
It can't
heat rejection through converctional or static means.(fan or air cooled condenser)
what two places heat be deposited in a water cooled condenser
heat rejection through converctional or static means.(fan or air cooled condenser)
What are the symptoms of an cooled Condenser when the air leaving the condenser is hitting a barrier and recirculating?
Refrigerant enters the condenser as a high pressure vapor. In the condenser, the heated refrigerant is cooled by transferring its heat to the air which passes through the condenser fins, and it changes state to a liquid during this time.
ac condenser means "Air Cooled Condenser". The cooling media is Air. The fluid or anything which is being circulated through (inside) the coils /tube being cooled by the exposed or forced air - which impinges over the outside of the coil / tubes. B.Kannan balakannan@live.com
The condenser is a coil in a refrigeration system. It is on the low pressure side and is exposed to ambient air temp. The refrigerant goes through that and is cooled off and is then sent to the compressor.
The heat absorbed by the condenser medium in a water-cooled condenser can be deposited either into the environment through the cooling water, which carries the heat away from the system via a cooling tower, or into another part of the system to be reused for heating purposes, like in a heat exchanger for a district heating system.
When a system with a water-cooled condenser cycles off, the water regulating valve should
When a system with a water-cooled condenser cycles off, the water regulating valve should
The approach temperature difference (ATD) is used to determine the condenser performance of a water-cooled condenser. It is the temperature difference between the refrigerant condensing temperature and the cooling water inlet temperature. A lower ATD indicates better performance and efficiency of the condenser.