why is extention
how which is right and which is wrong. You need a voltage standard with that you can calibrate both to the standard
When you switch a voltmeter from a lower to a higher voltage range, an additional resistor is added in series with the meter, increasing the voltage necessary to create the same voltage drop across or current flow through the actual meter movement.
A voltmeter connected in parallel.
You'd potentially damage the meter. Whether you do or not is immaterial; if the meter cannot measure the range of voltages you are expecting, it will not give accurate readings over that voltage range, thus you should not use it. Buy a different meter that will measure over that voltage range, or use a voltage divider circuit to get a lower voltage at a certain ratio of what is actually in the circuit (this may be difficult to do, or very simple depending on the circuit tested - the key is you do not want to load the circuit with the voltage divider network).
why is extention
Voltmeter connect in parallel with the circuit setting on voltmeter highest range first then to lower range. Ohmmeter we need to use the ohmmeter meter setting connect across the resistor
The formula for calculating the least count of a voltmeter is least count = Range / Number of divisions. Where the Range is the maximum voltage that the voltmeter can measure and the Number of divisions is the total number of divisions on the voltmeter scale.
If the voltage measured exceeds the voltmeter range then the voltmeter needle remains in it's maximum position until it's voltage values are considerably reduced.
With the pointer mid range on the scale, the reading of the multi-range voltmeter would be 125 volts.With the pointer mid range on the scale, the reading of the multi-range voltmeter is 125 volts.
2 volts
Multi-range ammeter using universal shunt
If the voltage is completely unknown, a voltmeter should be set to the maximum range first, then stepped down to an accurate level.
if we would like to expand the range of voltmeter we should change the voltmeter resistance even to be appropriate . we should use a variable resistance to control of its value . I would extend the range of a voltmeter by adding resistance in series with it. I would extend the range of an ammeter by connecting resistance in paerallel with it.
The price of a voltmeter can vary depending on the brand, model, and features. On average, a basic analog voltmeter can range from $10 to $50, while a digital multimeter with more advanced capabilities can range from $20 to $200 or more.
how which is right and which is wrong. You need a voltage standard with that you can calibrate both to the standard
The normal range of motion for shoulder extension is typically between 50 to 60 degrees.