to help identify the location of the drive
since the array is four elements and array subscripts start at zero, the valid ones would be 0, 1, 2, 3
To determine the largest subscript that can be used with an array, you need to know the array's size and indexing conventions. In most programming languages, array subscripts start at 0, so if the array has a size of n, the largest valid subscript would be n - 1. If the array is defined with a different starting index, such as 1, then the largest subscript would be n. Always check the specific language's documentation for details on array indexing.
Well the most prolific answer to this query would be the use of pointers.Use a pointer and allocate it to the array of interest and start printing.
There are no array operations in C. Arrays implicitly convert to pointers, thus any operation you might attempt upon an array you would actually perform on a pointer.
You would sort the given elements of an array by a bubble sort or heap sort code!!
Computer has detected a problem with the transmission.
The negative prefix of "array" would be "non-".
It indicates transmissions problems. Had this happen at 103,000 km on our 2002 Honday Odyssey and had to replace the entire transmission.
First thing I would do is to trie puting it into drive or reverse to maybe it will kick in. If that doesnt work. You might have a bad 4 wheel drive selecter. Its a little black box on the side of the transfer case.
With a scan tool, or try turning key on, off, on, off, on and counting the blinks of the check engine light. blink, blink, blink, pause, blink would be 31.
Why would you want the blinker faster. They should blink at factory specs.
you couldn't tell because a cyclops has only one eye.. but i would say if it was just blinking it would look like a blink.. but if it were smiling and it blinks I would think it was a blink because of the smile on his face
All of the drive lights (and most of the other dash lights) are attached to sensors related to correlated vehicle parts (ie the oil light for oil pressure, gas light for low fuel levels, etc.). When the drive lights start to blink that means one of 2 things, either your transmission is failing or the sensor attached to the transmission is failing. I hope for your case it is the latter. Suspect a bad four wheel drive module, or wheel actuator
You would insert this command right after your array values have been specified.document.write(name of array[Number on array this item is, starts at 0])
With some difficulty! It would be an array with 6 rows and 3546 columns.
Different manufacturers use different blink rates. It is the choice of the designer. There isn't any standard blink rate. Data packets flowing on the cable move so quickly that if a blink rate was not used, the LED would flash too quickly, and it would be hard to see it working.
since the array is four elements and array subscripts start at zero, the valid ones would be 0, 1, 2, 3