answersLogoWhite

0

No

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What happens when a voltmeter is connected in series with load?

when we connected voltmeter in series it takes large current and voltage and the resistance is considerably decreases.this is why we had connected voltmeter in series combination.


How does the voltage across a load is measured in a circuit with alternating current?

The voltage across a load in a circuit with alternating current is typically measured using a voltmeter. The voltmeter is connected in parallel to the load, allowing it to measure the effective voltage or RMS voltage across the load. This value represents the average voltage of the alternating current waveform.


Why is the voltmeter is placed across the load to be measured?

Because that is what you are trying to measure.


How are voltmeter connected to circuit?

Usually a voltmeter is connected across the load whether or not it is AC (Alternating current) or DC (Direct Current). A voltmeter is never connected in series with the load as this may cause serious injury or damage. The meter will absorb the full potential .


How is ammeter and voltmeter attached to a circuit?

Ammeters are connected in series with the load under test. This requires the load be disconnected from the source, and the ammeter placed in circuit. Voltmeters are connected in parallel with the load under test. This does not require any circuit changes. Sorry, but WikiAnswers does not support illustrations.


How should a voltmeter be connected to measure voltage of a component?

Since voltage is electrical potential difference, to measure the voltage across a component, you place the voltmeter across, or in parallel with, the component.


The function and use of an ammeter and a voltmeter?

A: ACTUALLY they are both the same just the application makes one or the other. Their function is to measure potential difference on a load or circuitry


How do you test a cars alternator?

1st you start up the car. Hook up a voltmeter to the battery, and put a load on the battery as the car is running (have the lights on, radio on, high beam on,...) after you put a load on the battery read the voltmeter. if it goes below 12 the alternator is bad. It souldn't be no more than 14 volts. you can also use the battery gauge but to be 100% sure hook voltmeter to the alternator.


How can you tell the power and voltage when their is no current?

If there is no current, there is no power.The voltage can be measured with a voltmeter.


The rules of connecting voltmeter and ammeters in the circuit?

Connect ammeter in series and voltmeter in parallel to the circuit


If a voltmeter is hooked up in series it will?

It will prevent almost all current from flowing the circuit, since a voltmeter has a very high electrical resistance. Only ammeters (or milliammeters) should be wired in series between a power source and its load.


Where does the volmeter and ammeter go in a circuit?

after incomer & before outgoing feeder, we connect ameter to measure amps.AnswerThe voltmeter is connected in parallel with the load and the ammeter is connected in series with the load, if you wish to measure the potential difference across, and the current through, that load.