I don't have an answer but we have several large magnets in the shop I work in. It would appear that when we lower the cranes down and place the magnets directly on the concrete floor it tends to weaken them. I have always heard that placing a car battery on concrete would weaken the battery . Does a magnet act in the same fashion?
Reinforced concrete is made by placing steel bars in the tension zone of the beam x-section.
yes
Yes, concrete can damage ABS (Acrylonitrile Butadiene Styrene) pipe if it exerts excessive pressure or weight on it, leading to cracks or breaks. Additionally, if concrete is poured directly onto ABS pipe without adequate support or protection, it can create stress points. It's essential to ensure proper installation and support to prevent potential damage.
Limit state design is designed a concrete member for its various damage limit states, concrete sover spalling, steel yielding all the way up to the crushing of the concrete core, with this you can control how you want the concrete member to fail.
Because the cement will damage
creates magnetic force
Placing a magnet near them for a short time can corrupt or delete the data; this also applies for computer hard-drives and some other storage devices.
No the magnet will have no impact on your phone
Over time, ants can damage concrete. However, if you keep all the cracks in concrete caulked, it will prevent the ants from damaging the concrete.
To erase a floppy disk with magnets, you would need a strong magnet, such as a neodymium magnet. By placing the magnet close to the disk's magnetic media, the magnetic fields can disrupt the data stored on the disk. However, this method is not highly reliable, as the effectiveness depends on the strength of the magnet and the type of disk. Additionally, using magnets can potentially damage the disk, making it unusable.
The iron filings experiment demonstrates that a magnet's force can pass through certain materials. Placing iron filings on a piece of paper and then placing a magnet underneath the paper will cause the filings to align along the magnetic field lines, showing that the magnet's force is able to pass through the paper.
day
You cannot make a magnet stick directly to aluminum because aluminum is not magnetic. However, you can make a magnet stick to aluminum by placing a magnetic material, such as iron, in between the magnet and the aluminum surface.
electromagnetic induction
Reinforced concrete is made by placing steel bars in the tension zone of the beam x-section.
To redo concrete floors effectively and efficiently, follow these steps: Clean the surface thoroughly to remove any dirt or debris. Repair any cracks or damage in the concrete. Apply a concrete resurfacer to create a smooth and level surface. Use a concrete sealer to protect the floor and enhance its appearance. Allow sufficient drying time before walking or placing furniture on the floor.
which concrete resist frost action