answersLogoWhite

0


Best Answer

There is no overdrive, per se, but a mode switch called "Power Mode" that doubles as an overdrive, allowing more RPMs per gear.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

15y ago

on the gear shift

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the switch for the overdrive in the Isuzu Rodeo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace ignition lock cylinder Isuzu rodeo?

How I can replace ignition switch cylinder from Isuzu Rodeo?.


Where is the emergency cut off switch on a 1998 Isuzu rodeo?

there is not one


Where is the automatic shut-off switch located on a 1992 Isuzu Rodeo 2WD?

There is none.


When did they stop making the Isuzu Rodeo?

The last Isuzu Rodeo was in 2004.


Why does my 2001 Isuzu Rodeo rear wiper not turn off?

If the rear wiper on a 2001 Isuzu Rodeo will not turn off it could mean that the rear wiper switch is broken. The cost to replace the switch averages around $200 if done by a professional mechanic.


Where is the automatic fuel switch shut off located on a 1992 Isuzu Rodeo?

In recent experience, I have learned that a 1992 rodeo does not have a cut off switch and that on most the fuel pump is in the tank!


Why won't a 1998 Isuzu Rodeo transmission shift from third to overdrive?

Could be low fluid,a bad sensor or transmission going bad.


How to Adjust the parking brake on an Isuzu rodeo?

adjusting Isuzu rodeo brakes


Will a 1999 Isuzu Rodeo headlight work on a 2001 Isuzu Rodeo?

Yes


Will a 1993 Isuzu Rodeo windshield fit a 1996 Isuzu Rodeo?

Yes.


Where is the starter relay switch on 2001 Isuzu Rodeo?

passenger side under hood inside fusebox


Isuzu rodeo won't start?

I just found. Out why wife 2000 Isuzu rodeo why it wouldn't. Crank! The electrical switch in the stearing column.(the little round switch. On the other side of the key ) Had one side of the two tab in it broken! The switch. Would. Turn on but the starter wouldn't turn the motor! That was the problem!