Yes, you can replace the dash clocks in a 1999 Corsa with ones that include a rev counter, provided they are compatible with your vehicle's wiring and electronics. It's important to ensure that the new clocks are from a similar model and that the connections match. You may also need to adjust the ECU settings if applicable. Consulting a professional or a detailed guide is advisable for the installation process.
Most likely the bulb has blown. you need to remove the clock and two bulbs in the back (halfords 509t) to remove the clock. take out the two blower vents. there are two screws behind undo these and the clocks off. sam
you have to take off the cowl around the clocks, then the clocks just unclip from the dashboard (no wires or cables) and pop out the wasted bulb and replace with the new one. while your at it, why not put in coloured bulbs for the clocks, to pimp it a bit replacing is just as easy as taking the clocks out
To change the fuse for the clock in a Vauxhall Corsa Twinport, first, locate the fuse box, which is typically found behind the dashboard on the driver's side or in the engine compartment. Use a fuse puller or pliers to remove the relevant fuse, which is usually indicated in the owner's manual. Replace it with a new fuse of the same amperage, ensuring it is securely in place. Finally, test the clock to confirm it is functioning properly.
t5 bulb
yes they have to be coded
how do you change a heater matrix on 1.2 corsa 52 plate
You have to remove the airflow on the front panel underneath the clock . You will find two small screws. undo those and the clock will pull up. Unclip the power feed wire and turn the bulb anti clockwise to remove.
No, the clock spring is a connector and is not considered an active sensor.
How do you change a sidelight bulb on a 53 plate corsa
2000
To change the bulbs on the clock temperature display in a 2002 Vauxhall Corsa, first, disconnect the car battery for safety. Remove the dashboard trim surrounding the display, which may require a flathead screwdriver or a trim removal tool. Once the trim is off, gently pull out the display unit and locate the bulb holders at the back. Twist or pull them out to replace the burnt bulbs, then reassemble everything in reverse order.
you have got to change the hole bumper