answersLogoWhite

0

this requires a drive shaft company that can cut and weld it and balance it after.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Does a 2001 ford ranger have a vehicle speed sensor?

Yes, you would most likely find it on the tail shaft housing on your transmition. That is towards the rear of the transmition near where the drive shaft enters the transmition. The sensor will have a 3 wire conector on it. It does not matter if it is a manual or automatic.


Three differences between a drive shaft and a prop shaft?

1) Drive-shafts are used on FWD but Prop-Shafts are used on RWD or 4WD. 2)A Drive-Shaft has final drive via a CV joint but a Prop-Shaft has final drive via a Differential. 3)A Drive-Shaft is smaller, lighter and saves space by not having a transmition tunnel.


What is the name of the gearbox shaft which is 'splined' to accept the clutch plate?

front transmition shaft Input Shaft


Will a 2002 mustang 5 speed transmission work in 1990 mustang?

Yes, You may have to change the tranny support and shorten the drive shaft but it will fit.


How can you shorten a weed eater shaft?

hacksaw :P


What are the advantages of a shaft drive bike compared to a chain or belt drive bike?

A shaft drive bike has advantages over a chain or belt drive bike in terms of lower maintenance requirements, cleaner operation, and longer lifespan.


Is the transmission from a 1982 Chevy interchangeable with a transmission from a 1988 Chevy?

Yes but you may have to shorten the drive shaft if it is a 350 turbo going to a non electronic 700r4


What is needed to use a 76 chevy 350 with a 83 700r4 trans?

drive-shaft shorten also: make sure the tv cable is installed and properly set.


What would happen if the half shaft and intermediate shaft separated?

The vehicle would no longer move on its own unless you have a 4 wheel drive vehicle.


Who invented the drive shaft and when?

A drive shaft allows torque to enter a motor. Louis Renault of France was the inventor of the drive shaft. He invented the drive shaft in 1898.


Can you use a 2wd tailshaft housing on a 4x4 350 transmission?

NO. NO. The reason you can't is because the center shaft in a 2-wheel drive transmission is shorter then a 4-whell drive transmission. The 4-wheel drive trans. has a transfur case that slides over the center shaft, so the shaft must be longer.


Are 4 wheel drive turbo 350 transmissions different then regular turbo 350 transmissions?

the 2wd turbo 350 has a longer tail shaft NEW ANSWER: The center shaft in a 4x4 transmission is longer then a 2 wheel drive trans. The reason is that it has a transfur case on the end of it, and the center shaft must fit into the transfur case to make it work.