To change the oil filter housing on a 1997 VW Cabrio, first ensure the engine is cool and disconnect the battery. Remove the old oil filter and drain any remaining oil from the housing. Then, unbolt the oil filter housing from the engine block, replace any gaskets if necessary, and install the new housing, ensuring it's tightened to the manufacturer's specifications. Finally, reinstall the oil filter, refill the engine with oil, and reconnect the battery.
inside the oil filter housing
The 1997 Acura intake air temperature sensor is located on the air filter housing. The sensor will be on the right hand side of the air filter housing.
The air filter of a 1997 Dodge Neon coupe is located in the air intake of the vehicle. Standard intakes use a plastic housing which flows throughout the engine bay. Locate the housing for the filter and remove the clips from the air box. Open the box and replace the filter.
By not changing it, because it does not exist.
3.3 quarts
Start with changing the fuel filter.
The filter is located behind the glove box. You remove the 2 screws at the top of the glove box and pivot it down to expose the filter housing. Press in the clip on each side of the filter housing and pull the filter out. You may find your truck does not even have this filter as it was an option in 1997 so I would look there first before buying one. If you purchase a Purolator Cabin Filter it comes with complete instructions.
195 60 14 low profile wheels are perfect for the VW Cabrio.
It is on the passenger's side fender well under the air filter housing
try the glove compartment...
4.5 quarts with oil & filter change.
Driver's side front of engine in a plastic housing