0
There is one fuse for the entire power seat system. Most likely the switch is broken or the wires between the switch and the seat are shorted---they run through the door jamb and tend to wear out from constantly being flexed back and forth. Try jiggling the switch back and forth in the direction you want it to work, while opening and closing the driver's door slowly. You will probably hit on one door position where the seat back motor activates. The long-term fix is to remove the inner door panel and repair the broken wires. The switch itself can easily be removed, disassembled, and cleaned at the same time, or you can just replace it. Good luck
What else can I help you with?
How do you do separate trail mix?
You separate the parts of it manually by picking the individual pieces of food out.
Why people rather than machines need too manually separate some of the recycling mixture?
It is a method more sure and selective.
Is ASL an example of manually coded English?
no ASL or american sign language is a unique language of its own. It is separate from the English language. Manually coded English is a form to fit hand signals with the english word. I hope that helped
What is position Account?
a separate account thant eh general ledger
How can you change a camshaft position sensor on your Chevy astro van 1988?
Camshaft position is taken from the distributor, there is no separate sensor.
Who were the protagonists in the movie separate but equal and what was their position the conflict?
charles l.black,jr
Where is the camshaft position sensor located on a 1999 Mercury Villager?
Cam position is taken from the distributor on this vehicle, there is no separate cam sensor.
Can you separate oil from water using spoon?
No, you cannot separate oil from water using a spoon. Oil and water do not mix, so they will not combine easily. To separate them, you can use a method like allowing them to settle and then manually removing the oil layer with a tool like a pipette.
What is an example of a reversing linkage?
train
How do you replace the rear seat in a Crown Victoria?
the seat itself is separate from the backrest and must be removed first if you plan on taking out the backrest as well. to remove the seat, simply push the lower front towards the rear of the vehicle and lift up. if you do it correctly, you will release the two hooks that slide through two holes mounted to the floor itself. take the seat out of the car and look at the backrest. you should now see two bolts that were previously hiddem by the seat cushion. Not sure what size they are, but unbolt them and I believe the backrest slides UP and off two similar hooks that keep the top anchored to the rear deck. When you go to reinstall, don't forget about the seat belts. you don't want to backtrack if you don't have to; the little claw mounts can be tricky to manipulate! good luck, travis gza069@hotmail.com
What do you mean by separate?
they mean that your position is getting filled. you no longer are employed their. you lost your job
How did the union and confederate lines position themselves at Gettysburg?
They positioned themselves along separate ridges
