0
There are two screws on the inside of the rear lift gate where the handle is on the inside. Remove those two screws. Then by the piece that locks down the lift fate are two plastic clips remove these two. then pull down a little on the plastic rugged panel to expose more plastic clips. With a long screw driver pull down to remove on both sides until you see the light socket. Turn the socket and remove the bulb to replace. install in reverse order. good luck
What else can I help you with?
How to Replace Volkswagen polo brake light bulbs?
To replace the brake light bulbs on a VW Polo, pull away the carpeting in the trunk, unscrew the bolt holding the lights on, and disconnect the wiring. Replace the bulbs, put the wiring and bolts back, then replace the carpeting.
Replace tail light 2004 Mitsubishi endeavor?
Take 2 screws out and pull light straight back, it will come over, replace bulbs and put back on and replace screws
How do you replace headlamps on a 2000 Accord?
The bulbs unscrew counterclockwise from the back of the light assy. Sometimes you ave to remove the light to get to it.
How can I replace long light bulbs?
To replace long light bulbs, first turn off the power to the fixture. Allow the bulbs to cool if they were recently on. Next, carefully remove the old bulbs by twisting them out of the sockets. Insert the new bulbs by twisting them into place. Finally, turn the power back on and test the new bulbs to ensure they are working properly.
How do you replace the headlight bulb located on a 2000 Chevy Malibu?
The bulbs unscrew from the back of the light assy. sometimes you have to remove it to get to the back.
If a back tail light goes out and you replace one of the bulbs but the lights still do not come on does a fuse need to be replaced?
Check the ground on the light.
How do you replace the front running light bulbs on a 94 Saturn SC2?
Open the hood as the light bulb pop into the back side of the lens
How do you replace the charge indicator lamp on 1992 Thunderbird?
take out instament cluster and all light bulbs are on the back
How do you get to the rear brake light bulbs on a 1999 Nissan Frontier?
You have to unbolt the entire tail lamp assembly to change the bulbs. Unbolt the tail lamps from inside the corners of the bed, replace the light bulbs, bolt the tail lamps back in place.
What would cause no back-up light and turn signals to light up from back-up lights and all bulbs are new?
Repair or replace your reverse, neutral safety switch.
Why does this happen Brake lights and turn signal not working in back?
It sounds to me like your bulbs are out. These bulbs have a lifespan just like the light bulbs in the lamps that you have at home. These are easy and cheap to replace, and you can usually access the bulbs from your trunk, if you own a car.
How do you change the 3Rd brake light in a 2001 intrepid?
You must first remove the Trunk liner back far enough to get to the light cavity. There are two bulbs that make up the center third brake light. Just twist the light out of the lock position and replace the bulbs with appropiate replacements and then screw back in.
