Set up an appointment with a dealer, show up to appointment, drop car off, wait to be called, pick up car and pay bill.
To replace the blower motor on a C230 compressor of a Mercedes Benz, remove the bolts holding the motor in place. It is next to the blower, under the passenger side of the dashboard. Replace with new and reinstall the bolts.
The blower motor on a Mercedes Benz 300e is changed by disconnecting the wiring harness and unbolting the blower from its housing. The motor is then lifted away and a new blower motor connected.
under the pasenger side dash
To change the AC blower on a 1987 Mercedes-Benz 420 SEL, first disconnect the negative battery terminal for safety. Remove the passenger side under-dash panel to access the blower motor. Disconnect the electrical connector and remove the screws securing the blower motor in place, then take out the old motor and replace it with the new one, reassembling in reverse order. Finally, reconnect the battery and test the blower to ensure it's functioning properly.
The blower motor in a 1994 Mercedes-Benz E320 is located under the dashboard on the passenger side of the vehicle. To access it, you typically need to remove the glove compartment and the cover panel beneath the dashboard. The blower motor is mounted to the HVAC housing, making it accessible for replacement or repair.
well, how do you replace the motor mounts on this car?
The blower motor in a 1994 Mercedes-Benz S420 is typically located under the dashboard on the passenger side. To access it, you may need to remove the passenger side footwell panel and possibly the glove compartment for easier reach. The blower motor is usually housed in a plastic casing near the firewall, connected to the HVAC system.
where is the blower location the Mercedes Benz 300 d
its under globe compartment, remove screw attach to the cover, and you will see wiring harness. that's were the regulator located unscrew and replace it.
email me at jacks1456@yahoo.com and I will try to send you the schematic
remove right side under dash panel remove blower cover unplug motor remove motor and blower regulator swap regulator on to new motor note all u need is a philpps head and a 15 and 25 torques
Under the cabin filter box under the hood r/s firewall