answersLogoWhite

0

To remove the B-pillar lower trim on a Jaguar X-Type, start by carefully prying off any plastic covers or caps that may conceal screws. Use a Torx or Phillips screwdriver to remove the screws securing the trim in place. Once the screws are removed, gently pull the trim away from the pillar, being cautious not to damage any clips or fasteners. If necessary, use a trim removal tool to help release stubborn clips.

User Avatar

AnswerBot

3d ago

What else can I help you with?

Related Questions

How do you remove a automatic seat belt track and motor on a 1993 Saturn SC2 and where is the motor to the seat belt track located on this car?

remove the pillar moldings "b" and the trim along the track. There are 10 mm nuts and bolts holding the track. The motor is in the bottom of the "B" pillar remove the pillar moldings "b" and the trim along the track. There are 10 mm nuts and bolts holding the track. The motor is in the bottom of the "B" pillar


Where is the Fuel Pump Driver Module located in a 2004 Ford Freestar?

The fuel pump driver module is located under the driver's side B-Pillar interior trim about 6 inches above the floor. The B-pillar is the pillar between the front doors and the sliders. Push the driver's seat forward, remove the pillar trim and you will see it right away.


How do you remove the Rear deck to change rear speakers in a 2000 dodge stratus?

REAR SPEAKER - JR41 Disconnect and isolate the battery negative cable. Fold down the rear seat backs. Remove C-pillar trim. Remove lower quarter trim behind rear seat backs. Remove fasteners from rear shelf trim. Pull out trim to access speaker. Remove speaker screws. Disconnect wire harness connector. Remove speaker (REAR SPEAKER-JR41). REAR SPEAKER - JR27 Disconnect and isolate the battery negative cable. Using a trim stick, pry the speaker grill from the trim panel. Remove speaker mounting screws (REAR SPEAKER - JR27). Remove speaker from trim panel. Disconnect wire harness connector from speaker.


How do you replace the A window pillar trim on my 1999 dodge ram 1500 Or is it A and B window pillar trim Or R and L?

To replace the A window pillar trim on your 1999 Dodge Ram 1500, start by gently prying off the trim using a trim removal tool to avoid damaging the clips. You may need to remove any screws or fasteners securing it in place. If you're referring to the A and B pillars, the A pillar is located at the front of the vehicle next to the windshield, while the B pillar is between the front and rear doors. For a complete trim replacement, ensure you have the correct part for either the left or right side, as they are often specific to each side.


Where do you get door trim clips for a Jaguar XK8?

Jaguar or Ford Dealer


How do you remove the subwoofer from a 2002 Chevy Tahoe?

remove the plastic trip pieces around the subwoofer including the strip at the back of the vehicle and the pillar trim with the tweeter and unscrew it from the stock box


Where is the 1995 Ford Escort Seat Belt Motor located?

At the base of the pillar behind the door. One for each side. You have to remove the plastic trim.


When changing rear door on 1990 XJ6 how do you remove plugs that won't fit through wiring hole for harness?

There should be an access panel located in the B pillar, or if you remove the interior trim of the B pillar, a pair of connectors that are small enough to pass out through the B pillar. The wiring goes with the door, as opposed to staying with the car.


How do you take off door pull 2006 GMC?

Remove door trim handle bezel,triangle A pillar trim bezel and lock button manual sliding bezel remove two 7mm trim screw and lift door trim panel up to remove :note some panels may have a round plastic plug at frt and cap at rear if so pry softly out on frt of panel to remove plug and at the rear pop off cap and remove 20 toqures screw then lift off trim panel


How do you get to the rear speakers on a 1992 GMC sierra extended cab pickup?

If there are not screws in the speaker cover on the pillar then you will have to remove the entire section of interior trim. You need to use a trim removal tool to carefully pry by the fasteners.


Does a 2000 Chrysler Concorde have a factory amp if so where is it?

If equipped it is mounted under the dash on the passenger side 'A' pillar. You need to remove the under dash trim, remove two nuts, and pull amp out.


How do you remove radio from 2004 jaguar XJ8?

To remove the radio from a 2004 Jaguar XJ8, first disconnect the car battery to ensure safety. Use a trim removal tool to carefully pry off the surrounding trim panel without damaging it. Once the trim is removed, unscrew the mounting screws holding the radio in place, then gently pull the radio out and disconnect the wiring harness from the back. Be sure to handle the components carefully to avoid any damage.