Carefully pry pad wear sensor from brake pad. Then insert brake pad wear sensor into cutout in new pad where applicable.
how do you put disc brake bmw90 325i
1500.00 At the dealer,
remove the hex bolt on the rotor and give it a smack with a mallet
you may need to replace the sensor for the coolant, there should be a wire connected to it.
Where is the starter located on my 2003 BMW 325i
is in hard to replace a thermostat on a 2001 bmw 325i
How do you replace a waterpump on a 1990 BMW 325i
P2185 is ECT sensor high voltage detected. ECT stands for Engine coolant Temperature Sensor.
The brake pad sensor light is reset by leaving the key on engine off for about 20sec. If it does not reset retry, if it still does not reset check the wiring of the left front and right rear pad sensors
how to replace blower resister on a 325i BMW 2002
Hi well i am a Ex-Bmw tech. and a tech HAHA but there are 4 Oxygen sensor... there are 2 Pre sensor and 2 After sensor.. easy to see but sort of a Pain to replace. If its a E46 not a E36
when they first start to squeek, if you wait you will have to pay for a whole new sensor. that really sucks and costs a pretty penny. but you only have one sensor for the front it is located on the driver side. Dont let them try to get you. And one in the back. so two sensors total