Swith the Ignition Off
Hold Miloemeter Trip Reset In (keep held in)
Turn on Ignition
Still Hold Trip Reset for approx 12 seconds, the InSP should change.
Release trip reset.
Switch off ignition
Switch on ignition and check.
needs to be done with a diagnostics machine.
To reset the service spanner indicator on a 2003 Vauxhall Vectra 2.0 DTI, turn the ignition to the "ON" position without starting the engine. Press the accelerator pedal fully three times within five seconds. Then turn off the ignition. Upon restarting the vehicle, the service spanner light should be reset.
Disconnect Battery for an hour, reconnect... Done
Hold the break pedal down and the milometer trip button turn on the ignition whilst holding these in the service light will flash then resets
You don't!
If its vectra b to reset ECU you have to turn key so all display leds light up then off and do it 8 times if i remember rightly, this resets ECU to factory settings.
you will need this... VAUX-COM PC based tool for Vauxhall to recode the immobilizer
To reset the service light on a 2008 Vauxhall Astra, turn on the ignition without starting the engine. Press the accelerator pedal three times within five seconds. Then, turn the ignition off and back on to confirm that the service light has been reset. If the light remains on, repeat the process.
To reset the service light on a 2009 Vauxhall Corsa, turn on the ignition without starting the engine. Press the gas pedal three times within five seconds. Turn off the ignition, then start the engine to check if the service light has reset. If the light remains on, the process may need to be repeated.
hold milage reset button in and switch on ignition.hold for about 5 seconds and it will reset.
Just press the trip reset button
To reset the service light on a 2007 Vauxhall Agila, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal fully three times within five seconds. After this, turn the ignition off and then start the engine to confirm that the service light has been reset. If the light remains on, repeat the process.