0
if it is the new shape megane II with the funny shape rear end, open the boot. there is a wing nut thing and the top of the light unit attachin it to the body work, undo this. run your hand down the black vinyl until u find a large round circular cover on the side of the unit, remove the cover and remove the 2nd wing nut thing inside the cover. the unit is now free to be removed. stand square on to the rear of the car, facin the same direction as the car. gently pull the light straight towards you, DO NOT LIFT AND PULL, JUST PULL STRAIGHT TOWARDS YOU. this is because there are 2 pin like things which are holdin the unit into the cars body work, if u pull at an angle then these will snap off if the unit is pulled off the bodywork. once removed, there are 2 holders for lights, locate the bulb which is the brake light, and replace bulb, put light unit back on to car following the reverse of the above, ensuring it is pushed back straight not to damage the pins. replace the 2 wing nut things and recover the one with the black round plastic cover.
What else can I help you with?
How do you change the rear brake light in a Renault megane dynamique located above rear window?
did you figure out how to? mine has the same problem
How often do the brake pads for a Renault Megane need to be changed?
I own a diesel (1.9dti) Renault megane 2000 edition. I change the brake pads(front) every 15000 Miles approximately.
Where does the brake fluid on a Renault megane coupe go?
The brake fluid on a Renault Megane Coupe goes in the brake fluid reservoir. This can be located under the hood in the engine compartment.
How do you replace the handbrake cable on a Renault megane dynamique?
To replace the handbrake cable on a Renault Megane Dynamique, first, ensure the vehicle is securely raised and supported. Begin by removing the center console to access the handbrake mechanism, then detach the old cable from the handbrake lever. Next, trace the cable to the rear brakes, disconnect it from the brake shoes, and install the new cable in reverse order. Finally, adjust the cable tension and test the handbrake for proper function before reassembling the console.
What bulb is it for Renault megane 3rd brake light on megane2?
It could fit a T10.
How do you change the brake pads on a Renault megane?
To change the brake pads on a Renault Megane, first, lift the car and remove the wheel to access the brake caliper. Unbolt the caliper and carefully slide it off the rotor. Remove the old brake pads, then install the new ones, ensuring they are properly seated. Reattach the caliper, tighten all bolts, and replace the wheel before lowering the car. Always check the brake fluid level and pump the brake pedal to ensure proper function before driving.
Why won't Renault megane brake lights work It's not the 3no. bulbs and it's not the fuses?
The probable cause of the brake lights not working on your Renault is the brake light switch. The brake light switch can be found under the dashboard by the foot pedal.
How do i Change brake light on Renault megane scenic?
To change the brake light on a Renault Megane Scenic, first, open the tailgate and locate the rear light cluster. Remove the screws or clips holding the light assembly in place, then carefully pull the assembly out. Twist the bulb holder counterclockwise to remove it, replace the faulty bulb with a new one, and reassemble everything by reversing the steps. Make sure to test the brake light before securing the assembly completely.
Where are the bleeding points for Renault Megane scenic?
Brake bleeding, clutch bleeding, coolant bleeding. You need to be specific.
Where is the abs sensor on a Renault megane coupe?
On a Renault Megane Coupe, the ABS sensor is typically located near the wheel hub assembly. It can be found on each wheel, mounted to the brake caliper or the wheel bearing assembly, depending on the specific model year. To access it, you may need to remove the wheel and possibly the brake components. Always consult the vehicle's manual for exact locations and procedures.
Where is the abs sensor on a Renault megane coupe 06 located?
On a 2006 Renault Megane Coupe, the ABS sensor is typically located at each wheel hub, near the brake rotor. It is mounted on the wheel bearing assembly and is responsible for monitoring the wheel speed. To access it, you may need to remove the wheel and brake components depending on the specific design of the vehicle. Always consult the vehicle's service manual for precise location and replacement procedures.
How do you replace a Renault megane wheel bearing?
To replace a Renault Megane wheel bearing, start by safely lifting the vehicle and removing the wheel. Next, detach the brake caliper and rotor to access the hub assembly. Remove the retaining nut and use a hub puller to extract the old bearing from the hub. Finally, install the new bearing, reassemble the hub, brake components, and wheel, ensuring everything is securely tightened before lowering the vehicle.
