To change the heater matrix unit on a Vauxhall Vectra C, you need to start by disconnecting the battery and removing the dashboard to access the heating system. Drain the coolant and remove the hoses connected to the heater matrix. Then, detach the heater matrix from its housing, replace it with the new unit, and reassemble everything in reverse order, ensuring all connections are secure before refilling the coolant and reconnecting the battery. It's recommended to consult a service manual for detailed instructions specific to your model.
To change the heating matrix on a Vauxhall Vectra, first, ensure the vehicle is turned off and the battery is disconnected. Remove the dashboard and center console to access the heater unit, which typically involves removing screws and clips. Then, disconnect the hoses and electrical connections from the heating matrix, take out the old matrix, and replace it with the new one. Finally, reassemble the dashboard and reconnect the battery, ensuring there are no leaks in the system.
how to change antifreeze in vauxhall vectra B
How do I change the nearside headlight bulb on my Vauxhall Vectra 2007
Get A Mechanic Do It
if it has air condition it is behind the pollen filter under the bonet
how to change the heating plugs on a vauxhall vectra 1.9 and were are they located
how do i change the front bumper on my 1999 vauxhall vetra
remove radio out vauxhall vectra
There is a 'How To' on one of the Vauxhall owners websites. www.vvoc.com.uk 'Vauxhall Vectra Owners Club www.vectrasport.com.uk 'Vectra Sport www.migweb.com.uk 'Vauxhall Owners club www.cavweb.com.uk "Vauxhall Cavalier owners club but open to other vauxhall owners Same if you own Holden or Opel version Don Sutton
In the opel vectra it's on the side of the dash board passenger side. No. 2 - 7.5 A, and no. 23 - 30 A.
Vauxhall Vectra wiring diagrams: http://www.pdfoo.com/resultpage6~vauxhall-vectra-wiring-diagrams.html
To change the heater blower on a Vauxhall Vectra (52 plate), first disconnect the car battery to ensure safety. Remove the passenger side footwell trim panel to access the blower motor. Disconnect the electrical connector and remove any screws or clips securing the blower motor in place. Replace it with the new blower motor, reconnect everything, and reassemble the trim.