how to remove front outer door handle on a 2013ford fusion
I don't know - but the question about the 1993 door handle is the same...
How do you remove outer door handles on Nissan dualis
The interior door panel cannot be removed from the door. To work on the inside mechanisms of the door, remove the outer, plastic skin. First remove the outer door handle; lift the handle enough to expose the two pins that hold the handle to the door mechanism. Push the pins through and remove the handle. Next remove the screws around the perimeter of the door. They are visible when the door is open. After all of the screws are removed, lift the outer door skin off and you have full access to the inside of the door.
Since this question is in the Saturn area, it must be assumed that you are asking about removal of a Saturn door panel. The inner door panel of a Saturn is not removable, it is integral to the door frame. However, you can remove the outer door panel. First, remove the outer door handle; lift the handle enough to reveal the pins that hold the handle to the door latch mechanism, then press out the two pins and set the handle aside. Next, open the door and remove the screws around the perimeter of the outer door panel. After the screws are removed, the outer door panel should lift off easily.
The inside door panel cannot be removed; instead, to get to the inner workings of the door remove the OUTER panel. Lift the outer door handle to expose the pins that hold the outer handle to the door mechanism. Then press out the pins and remove the handle. Then remove the screws around the perimeter of the door that hold the outer panel. The panel should lift off, exposing all of the inner workings, then you can verify that the inner panel does NOT come off.
If it's the outer handle you would need to remove the door panel, then remove the rivits that hold the handle to the outside of the car. Then remove the window track and slide it down inside of the door and unhook the rod on the handle,and now you can slide the door handle out.
Lift the handle as though you are trying to open the door. Note that there are 2 pins in the part of the handle that connects to the door mechanism. Press the pins out, then the handle should slide right off.
Remove the OUTER door skin to get to the window hardware. Lift the outer handle, press out the two retaining pins then, with the door open, remove the screws that are around the edge. You will find some of them by examining the bottom inside of the door. After the screws and outer door handle are removed, the door skin just lifts off and you can get to all of the window hardware.
You will need to remove the inside door panel of your Chevy truck. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
Assuming you are referring to the outer door handle, remove the inner door panel and look at the back of the handle. You will see a couple of steel rods attached to the handle, remove these(they just unclip)and move them out of your way. You should be able to see a couple of small nuts holding the handle to the door. Remove these and the handle can be pulled out of the door from the outside.
To change a door handle on a 2004 Mitsubishi Endeavor, remove the 2 screws of the face plate. Then remove the 2 screws on the knob plate. Remove the door handle and replace with new.