My lad just replaced them on our 306 TD, they are the square ones that fit in to the front bumper. They are fastened on at the bottom by a large nut. As you face the headlights right hand one is accessed via an access hole in bottom of bumper and left hand is more easily accessed same way. Suggest you spray first with WD40 as they were fairly tight, had to swivel side to side & tap them using a piece of bar to get them out. Also had to flex the plastic back while someone did the tapping in order to get them out of the bumper hole. The wiring comes in via a shaped grommet that pops out & back in easily. One light was broke and other badly corroded so replaced with a pair made by Ring that got off ebay(genuine ones go for a lot), new ones look & work great; they are marginally smaller but that made easier to refit. Good luck.
To change the front fog lamp on a 2000 Peugeot 306, first, ensure the vehicle is turned off and the keys are removed. Access the fog lamp by removing the protective cover or the entire fog lamp assembly, which may require unscrewing a few screws or clips. Disconnect the electrical connector from the old fog lamp, replace it with the new one, and reconnect the electrical connector. Finally, reassemble any covers or mounting hardware and test the fog lamp to ensure it functions properly.
fanbelt on a 306 hdi how do fit it
6.5 inches.
Can anyone tell me where the front windscreen washer bottle is located on a Peugot 306
plug it
how to remove indicator stalk and cowl from Peugeot 306 lx
really easy fix! what model 306 is it? regards, Simon
In a Peugeot 306, the speakers are located inside the front doors. There should be four wires total, two for the speakers and two for the tweeters.
To change the wiper blade on a Peugeot 306 unclip the old part from the mount. Take the new wiper blade and slide it into place until it clicks.
front of the engine, behind the radiator in the centre
A Big Hammmer or angle grinder
no se como cambiarlo