It's a pain.
1) Discharge A/C system
2) Disconnect Negative Battery cable
3) Remove Driver's side airbag
4) Remove Steering Wheel
5) Remove Center Console
6) Remove Dashboard (yes, the whole thing)
7) Loosen cross member (the bar that supports the pedals and supports the dash.)
8) remove duct work
9) remove HVAC housing (seal off heater core lines to prevent coolant spill into vehicle.)
10) remove heater core from heater core housing.
11) slap new one in.
12) go through steps in reverse for reassembly. Use caution not to damage heater core seal or evaporator seal.
13) charge up the A/C after assembly.
Airbag malfunction light may come on after reassembly. Must be cleared with VAG tool. An honest shop should charge you for about 6 hours labor plus the cost of recharging the the A/C system and refilling any coolant lost. The core itself costs between $110 and $190 depending on the source. If you have never done this before, it will likely take about 12 - 18 hours depending on your skill level.
Remove the water supply hoses from your heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
how do i change a heater core on a 2000 Chevy impalla
see the answer for how do you replace heater core 96 jetta its the same good luck and god speed
I took mine to a local shop $1200.00 US
how do you change a heater core on a 2003 ss Monte Carlo
Those "fumes" are more than likely coolant steam coming from a leaky heater core. Replacing the heater core is your best option.
pull the dash
I have looked up time to change heater core on 2000 dodge caravan it said 2 hours. I have never done this so I need to know where to start?
To change the heater core in a 2000 Ford Expedition, first, disconnect the battery and drain the coolant from the radiator. Remove the dashboard and the center console to access the heater core housing. Disconnect the heater hoses from the core, unbolt the housing, and replace the old heater core with a new one. Reassemble by reversing the steps and refill the coolant before reconnecting the battery.
most of the time it the heater control unit on the motor not the heater core had same problem
To change the heater core on a 2000 Subaru Legacy, first, disconnect the battery and drain the coolant. Remove the dashboard and center console to access the heater core, then disconnect the hoses and any electrical connections. Remove the mounting bolts for the heater core and carefully pull it out. Install the new heater core by reversing the steps, ensuring all connections are secure before refilling the coolant and reassembling the dashboard.
To change the heater core on a 2000 Dodge Neon, first, disconnect the negative battery terminal and drain the coolant. Remove the dashboard and center console to access the heater core housing, then disconnect the heater hoses from the core. Remove the screws or bolts securing the heater core, take it out, and replace it with a new one, reassembling everything in reverse order. Finally, refill the coolant and check for leaks.