To get to the pump:
Remove front driver-side wheel
Remove Wheel arch trim, normally only 3-4 plastic retainers
and the pump is visible towards the front of the cavity
Hope this helps 80)
where will i find the windscreen pump on a saxo?
The washer pump is not fused on a clio as i have one and have recently changed it.
i took my windscreen washer pump off and cleaned it and cleaned tubes attached,put pump back on resorvoir but water still not coming out properly from front washer nozzles,any answers
In the 2008 Peugeot Boxer, the fuse for the windscreen washer pump is typically located in the fuse box under the dashboard on the driver's side. You may also find additional fuses in the engine compartment fuse box. To identify the correct fuse, refer to the fuse diagram usually found on the cover of the fuse box or in the vehicle’s owner manual. Make sure to check the specific amperage and label to ensure you are replacing the right fuse.
Under the water bottle
IN most vehicles, the windscreen washer pump is located inside of the water reserve canister.
Its in behind the passenger side front wheel arch
It is at the bottom of the washer bottle which is under the bonnet just in front of the windscreen on the left hand side.
Its located at the bottom of the water bottle. You can again access to it through the opening in the wheel arch on the drivers side.
To fit a windscreen washer pump to a Zafira A, first, disconnect the vehicle's battery to ensure safety. Remove the washer reservoir by unfastening any screws and disconnecting the hoses. Replace the old pump with the new one, ensuring it is securely seated and that the electrical connector and hoses are properly attached. Finally, reassemble the reservoir, reconnect the battery, and test the pump to ensure it operates correctly.
If its the same as the Picasso you will find the pump on the drivers side front wheel. you need to remove the wheel and liner to get access. after that it self evident.
To fix a windscreen washer system, first check the washer fluid reservoir to ensure it's filled. Next, inspect the hoses for any cracks or blockages and the pump for functionality; listen for a humming sound when activating the washer. If the pump is not working, it may need to be replaced. Lastly, clean the nozzles to ensure a proper spray and check the electrical connections for any faults.