How do you fit a clutch cable on a 1995 Rover 218?

Answer 1

R65 type transmission. Remove the air cleaner. Working in the engine compartment slide the clutch cable and fitting from the clutch release lever on the top of the gearbox. Release the cable sheath grommet from the bracket on the gearbox. Working in the drivers footwell release the 3 securing clips and remove the fusebox cover. Release the securing clips and remove the driver's side lower fascia panel . Reach up behind the fascia and unhook the end of the clutch cable from the pedal. Working in the engine compartment pull the cable through the bulkhead. Note cable routing and release the cable from any other retaining clips. Refitting Lubricate the cable bulkhead bush with rubber grease. Route the cable through the engine compartment and throught the bulkhead. Working in the drivers footwell reconnect the cable to the foot pedal then push the rubber bush on the cable fully into the bulkhead tube until the steel washer on the cable seats on the tube. Pull the clutch lever through its full range of movement to set the cable self adjustment mechanism. PG1 type transmission Remove air cleaner. Jack up front of vehicle onto axle stands. Working in the engine compartment slide the clutch cable and fitting from the clutch release lever on the top of the gearbox. Release the cable sheath grommet from the bracket on the gearbox. On right hand drive models release the cable from the clip attached to the coolant hose. Rest as for R65