30 mm
it sounds like your wheel bearing if its a whaling noise
could be a wheel bearing...or just that its a french car
To replace a Renault Megane wheel bearing, start by safely lifting the vehicle and removing the wheel. Next, detach the brake caliper and rotor to access the hub assembly. Remove the retaining nut and use a hub puller to extract the old bearing from the hub. Finally, install the new bearing, reassemble the hub, brake components, and wheel, ensuring everything is securely tightened before lowering the vehicle.
depends on wheel size mine are 185/65/15 and pressure is 36
in my megane it was in the spare wheel housing in the boot.
On a 2006 Renault Megane Coupe, the ABS sensor is typically located at each wheel hub, near the brake rotor. It is mounted on the wheel bearing assembly and is responsible for monitoring the wheel speed. To access it, you may need to remove the wheel and brake components depending on the specific design of the vehicle. Always consult the vehicle's service manual for precise location and replacement procedures.
Front hub/wheel bearing torque is 190-210Nm.
No, a Renault Scenic is front wheel drive. However, the rear wheels often wear faster than the front wheels, which would only normally happen with rear wheel drive. This is due to the unusual wheel alignment on this car.
remove drivers side front wheel, plastic panel behind spring/shock. real fiddly but can be done with minimal swearing ! if you have A/c then the air may be a tad bluer!
Go to a workshop! :)
To replace the suspension top bearing on a Renault Scenic, start by safely lifting the vehicle and removing the front wheel. Next, detach the suspension strut from the top mount by removing the nuts and bolts, then carefully take out the strut assembly. Replace the old top bearing with a new one, ensuring it is seated correctly, and reassemble everything by reversing the disassembly steps. Finally, double-check all connections and lower the vehicle back to the ground.