answersLogoWhite

0

The first thing to check is the switch. You can check it with a multimeter device with a continuity checker or ohm meter. The switch is usually on the door handle and in most cars it is held on by one screw. Remove the screw then slide the door handle either forward or backward then pull out. This will expose the wire harness to the switch. Disconnect it and remove the switch to test.

Also you can just run a hot and ground wire off a 12 V battery directly to the connect points where the switch plugged into the wire harness. If the problem was in the switch this will bypass it and open your door locks once you touch both the hot and ground wire to the contact points. There will be one common ground contact point and two hot contact points. One hot is for locking and the other is for unlocking. Touch the negative wire off your battery to the common ground then touch the hot wire off your battery to each of the other two contacts separately to see if both are working.

If the switch is working then the problem may be a disconnected wire harness, a shorted wire, a broken wire (open circuit) or faulty door lock actuators. To fix you must determine the source of failure then repair or replace what's needed.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How can I fix a door lock that won't lock?

To fix a door lock that won't lock, you can try lubricating the lock mechanism with graphite powder or WD-40, adjusting the strike plate alignment, tightening loose screws, or replacing the lock if necessary.


How do you fix the driver's side power door lock on a 1998 Honda Accord while the other door locks work fine with the remote or manually activated?

Sounds like you need to replace the drivers door lock actuator.


How do I fix the Passenger electric door lock on 2002 Mustang?

how do I fix a electric door on a ford mustang


How to fix power door lock?

2001 GMC Serria, power door locks.Driver side works perfect.Passager side does not.Pushing switch either side locks driver door but not passenger door.What is wrong


How do you fix a lock relay on a 1994 Honda accord ex?

You don't fix it, you replace the door lock actuator.


How can I fix a door lock that won't turn?

To fix a door lock that won't turn, try lubricating the lock with graphite powder or WD-40. If that doesn't work, the lock may need to be replaced by a professional locksmith.


How do you fix a car door lock that does not open from the inside?

Remove the door panel, find and repair the lock linkgage.


How can I fix a lock on a door?

To fix a lock on a door, you can try tightening the screws on the lock plate, lubricating the lock mechanism, or replacing the lock altogether if it is damaged beyond repair. If these steps don't work, consider seeking help from a professional locksmith.


Why would the driver side power door lock switch lock all doors except drivers door on 2001 Chevy Blazer?

I just had the same problem. You have to pull the door panel off and take the power door lock actuator out and replace it. My local Chevy dealer wants 250 dollars for it. Its not a cheap fix. Maybe you can find it at your local junk yard. From slamming the door numerous times it breaks the plastic and the motor has to much play to push the power lock down.


How do you fix power door lock on 1998 Honda civic?

it depends on whats busted, is it blown, is it a loose wire, is something stopping it?


How can I fix a sliding door lock that is not working properly?

To fix a sliding door lock that is not working properly, you can try cleaning the lock mechanism with a lubricant, adjusting the strike plate, tightening any loose screws, or replacing the lock if necessary.


How do you engage power locks on 1990 Volvo 240?

The power locks can only be engaged from the driver's door. You press down on the door lock on the driver's door and it will lock all the doors. Or you turn the key in the lock to the right in the door lock of the driver's door and it will lock all of the doors.