A seat belt in a Saturn might be stuck because there is also something else stuck in the latch. Use a small pin or crochet hook to probe around the outside part of the latch. Once the seat belt is unlatched, clean it out with tweezers and spray both ends with WD-40.
Once a seatbelt starts sticking its gonzo and needs to be replaced.
Just open the door.
Put your seatbelt on. Should be an easy fix.
rephrase that
To fix a seatbelt that won't pull out, make sure it is not twisted. Jerk on the belt gently and let it retract before trying to pull it out again.
Your car should be still on warranty, call your dealer and let him to have that headache.If you do not have warranty for your car. You have to remove the panel covering the belt assembly. Most likely you will have to replace it.
To fix a seatbelt that won't click into the lock, first inspect the seatbelt and buckle for any visible obstructions or debris that might be preventing a proper connection. Clean both the buckle and seatbelt latch thoroughly. If the issue persists, check for any damage to the buckle or the seatbelt mechanism, and consider consulting a professional for repairs or replacements if necessary. Always prioritize safety when dealing with seatbelt issues.
To release a stuck rear seatbelt, first, check for any twisted or jammed sections of the belt. Gently pull the belt to see if it will retract, and if that doesn’t work, carefully inspect the buckle and latch for debris or obstruction. If the seatbelt is still stuck, try pulling it out slowly while pressing the release button, or consult the vehicle's manual for specific troubleshooting steps. If the issue persists, consider seeking professional assistance to avoid damaging the seatbelt mechanism.
i have a 1993 saturn sc1.the relays in the sunroof keep the sunroof from working.anyway to fix it
Rear seat belts are stuck
To fix it I would recommed taking it to your nearest Ford/Lincold/Mercury dealership. If it is stuck forward however..... Where the belt should be in the driving position there is a screw, take it out. There is a manual override in there, turn it clockwise until you can move the belt to the proper position. Spyder
duck tape lots of duck tape